There is no need to set PCI bus mastering when device is not doing any DMA. Though on Intel Quark DMA is a part of UART IP and thus shares same device in Linux kernel. Enable bus mastering only for Quark case. Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> --- drivers/tty/serial/8250/8250_lpss.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/tty/serial/8250/8250_lpss.c b/drivers/tty/serial/8250/8250_lpss.c index b992346..d5ba991 100644 --- a/drivers/tty/serial/8250/8250_lpss.c +++ b/drivers/tty/serial/8250/8250_lpss.c @@ -183,6 +183,8 @@ static void qrk_serial_setup_dma(struct lpss8250 *lpss, struct uart_port *port) if (ret) return; + pci_set_master(pdev); + /* Special DMA address for UART */ dma->rx_dma_addr = 0xfffff000; dma->tx_dma_addr = 0xfffff000; @@ -280,8 +282,6 @@ static int lpss8250_probe(struct pci_dev *pdev, const struct pci_device_id *id) if (ret) return ret; - pci_set_master(pdev); - lpss = devm_kzalloc(&pdev->dev, sizeof(*lpss), GFP_KERNEL); if (!lpss) return -ENOMEM; -- 2.9.3 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
