From: Nicolae Rosia <nicolae_rosia@xxxxxxxxxx> fsl_lpuart cannot be used with kgdb because the kgdb initcall is called before the driver's init. Move kgdb to be initialized after all serial drivers have been inited. Signed-off-by: Nicolae Rosia <nicolae_rosia@xxxxxxxxxx> Signed-off-by: Stefan Golinschi <stefan.golinschi@xxxxxxxxx> --- drivers/tty/serial/Makefile | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/tty/serial/Makefile b/drivers/tty/serial/Makefile index 1278d37..8016ef9 100644 --- a/drivers/tty/serial/Makefile +++ b/drivers/tty/serial/Makefile @@ -62,13 +62,11 @@ obj-$(CONFIG_SERIAL_ATMEL) += atmel_serial.o obj-$(CONFIG_SERIAL_UARTLITE) += uartlite.o obj-$(CONFIG_SERIAL_MSM) += msm_serial.o obj-$(CONFIG_SERIAL_NETX) += netx-serial.o -obj-$(CONFIG_SERIAL_KGDB_NMI) += kgdb_nmi.o obj-$(CONFIG_SERIAL_KS8695) += serial_ks8695.o obj-$(CONFIG_SERIAL_OMAP) += omap-serial.o obj-$(CONFIG_SERIAL_ALTERA_UART) += altera_uart.o obj-$(CONFIG_SERIAL_ST_ASC) += st-asc.o obj-$(CONFIG_SERIAL_TILEGX) += tilegx.o -obj-$(CONFIG_KGDB_SERIAL_CONSOLE) += kgdboc.o obj-$(CONFIG_SERIAL_QE) += ucc_uart.o obj-$(CONFIG_SERIAL_TIMBERDALE) += timbuart.o obj-$(CONFIG_SERIAL_GRLIB_GAISLER_APBUART) += apbuart.o @@ -96,3 +94,6 @@ obj-$(CONFIG_SERIAL_MPS2_UART) += mps2-uart.o # GPIOLIB helpers for modem control lines obj-$(CONFIG_SERIAL_MCTRL_GPIO) += serial_mctrl_gpio.o + +obj-$(CONFIG_SERIAL_KGDB_NMI) += kgdb_nmi.o +obj-$(CONFIG_KGDB_SERIAL_CONSOLE) += kgdboc.o -- 2.5.5 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
