From: Charanya <charanya@xxxxxxxxxxxxxx> The Data loss was happening with current QCOM MSM serial driver during large file transfer due to simultaneous enabling of both UART and DMA interrupt. When UART operates in DMA mode, RXLEV (Rx FIFO over watermark) or RXSTALE (stale interrupts) should not be enabled, since these conditions will be handled by DMA controller itself. If these interrupts are enabled then normal UART ISR will read some bytes of data from Rx Buffer and DMA controller will not receive these bytes of data, which will cause data loss. Now this patch removed the code for enabling of RXLEV and RXSTALE interrupt in DMA Rx completion routine. Signed-off-by: Charanya <charanya@xxxxxxxxxxxxxx> Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx> --- drivers/tty/serial/msm_serial.c | 4 ---- 1 file changed, 4 deletions(-) diff --git a/drivers/tty/serial/msm_serial.c b/drivers/tty/serial/msm_serial.c index 96d3ce8..6262b18 100644 --- a/drivers/tty/serial/msm_serial.c +++ b/drivers/tty/serial/msm_serial.c @@ -388,10 +388,6 @@ static void msm_complete_rx_dma(void *args) val &= ~dma->enable_bit; msm_write(port, val, UARTDM_DMEN); - /* Restore interrupts */ - msm_port->imr |= UART_IMR_RXLEV | UART_IMR_RXSTALE; - msm_write(port, msm_port->imr, UART_IMR); - if (msm_read(port, UART_SR) & UART_SR_OVERRUN) { port->icount.overrun++; tty_insert_flip_char(tport, 0, TTY_OVERRUN); -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html