On Mon, Jan 25, 2016 at 12:00:53PM +0000, Greg Farrell wrote: > > Enable the UPF_BOOT_AUTOCONF flag in serial_omap_probe(). > This will cause serial_omap_config_port() to be run and > the hardware to correctly be flagged as supporting hardware > and software flow-control. > > Without this, it is not possible to enable flow control. > > Signed-off-by: Greg Farrell <greg@xxxxxxxxxxxxxxx> > --- > drivers/tty/serial/omap-serial.c | 5 ++++- > 1 file changed, 4 insertions(+), 1 deletion(-) > > diff --git a/drivers/tty/serial/omap-serial.c > b/drivers/tty/serial/omap-serial.c > index b645f92..5e82238 100644 > --- a/drivers/tty/serial/omap-serial.c > +++ b/drivers/tty/serial/omap-serial.c > @@ -1664,7 +1664,10 @@ static int serial_omap_probe(struct platform_device > *pdev) > sprintf(up->name, "OMAP UART%d", up->port.line); > up->port.mapbase = mem->start; > up->port.membase = base; > - up->port.flags = omap_up_info->flags; Even if I wanted to apply this patch, it's line-wrapped and whitespace damaged :( -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
