Hi,
On 27/01/16 11:58, Lothar Waßmann wrote:
If a driver has no support for RTS/CTS (e.g. due to the missing
fsl,uart-has-rtscts property for i.MX UARTs) then trying to enable HW
flowcontrol via the TCETS ioctl should fail (as is the case with the
i.MX serial driver).
Thus it should be impossible to enable crtscts if the serial driver has
no RTC/CTS support without any need for userspace to know about the
HW details.
It doesn't do that for me [kernel 4.4]
The stty command to activate rtscts does return an error if the hardware
doesn't support it.
# stty -F /dev/ttymxc1 crtscts
stty: /dev/ttymxc1: unable to perform all requested operations
But the TCETS ioctl itselfdoes not fail:
ioctl(0, SNDCTL_TMR_STOP or TCSETSW, {B115200 -opost -isig -icanon -echo
...}) = 0
ioctl(0, SNDCTL_TMR_TIMEBASE or TCGETS, {B115200 -opost -isig -icanon
-echo ...}) = 0
ioctl(0, SNDCTL_TMR_TIMEBASE or TCGETS, {B115200 -opost -isig -icanon
-echo ...}) = 0
write(2, "stty: ", 6stty: ) = 6
write(2, "/dev/ttymxc1: unable to perform "..., 56/dev/ttymxc1: unable
to perform all requested operations) = 56
The error message is because stty does a TCGETS afterwards and errors if
the result is different to that requested.
slattach does not compare the requested and actual configuaration
The kernel code in the imx driver is:
static void
imx_set_termios(struct uart_port *port, struct ktermios *termios,
struct ktermios *old)
{
...
if (termios->c_cflag & CRTSCTS) {
if (sport->have_rtscts) {
ucr2 &= ~UCR2_IRTS;
if (port->rs485.flags & SER_RS485_ENABLED) {
/*
* RTS is mandatory for rs485 operation, so keep
* it under manual control and keep transmitter
* disabled.
*/
if (!(port->rs485.flags &
SER_RS485_RTS_AFTER_SEND))
ucr2 |= UCR2_CTS;
} else {
ucr2 |= UCR2_CTSC;
}
} else {
termios->c_cflag &= ~CRTSCTS;
}
} else if (port->rs485.flags & SER_RS485_ENABLED)
So requesting RTSCTS if the hardware doesn't support it does not
generate an error but the bit is reset in the termios structure.
This makes sense to me. Userspace can ask for something - the driver
does it's best and reports to userspace what it actually did.
It's then up to userspace to decide if that's acceptable.
And indeed "man termios" :
"Note that *tcsetattr*() returns success if /any/ of the requested
changes could be successfully carried out. Therefore, when making
multiple changes it may be necessary to follow this call with a further
call to *tcgetattr*() to check that all changes have been performed
successfully. "
Martin
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
