The tx_stop() call turns the interrupt off, but the tx_start() does not
check if the interrupt is enabled. Switch it back on if there is more
work to do.
Signed-off-by: Ben Dooks <ben.dooks@xxxxxxxxxxxxxxx>
---
drivers/tty/serial/meson_uart.c | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/tty/serial/meson_uart.c b/drivers/tty/serial/meson_uart.c
index 12436cc..6c36526 100644
--- a/drivers/tty/serial/meson_uart.c
+++ b/drivers/tty/serial/meson_uart.c
@@ -144,6 +144,7 @@ static void meson_uart_start_tx(struct uart_port *port)
{
struct circ_buf *xmit = &port->state->xmit;
unsigned int ch;
+ u32 val;
if (uart_tx_stopped(port)) {
meson_uart_stop_tx(port);
@@ -167,6 +168,12 @@ static void meson_uart_start_tx(struct uart_port *port)
port->icount.tx++;
}
+ if (!uart_circ_empty(xmit)) {
+ val = readl(port->membase + AML_UART_CONTROL);
+ val |= AML_UART_TX_INT_EN;
+ writel(val, port->membase + AML_UART_CONTROL);
+ }
+
if (uart_circ_chars_pending(xmit) < WAKEUP_CHARS)
uart_write_wakeup(port);
}
--
2.6.2
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
