Hi Matwey,
On 11/07/2015 05:09 AM, Matwey V. Kornilov wrote:
> When 8250 driver doesn't have its own hardware RS485 support and doesn't
> want to override rs485_config callback, then default
> serial8250_rs485_config is used. It just stores supplied by user-space
> config.
>
> Signed-off-by: Matwey V. Kornilov <matwey@xxxxxxxxxx>
> ---
> drivers/tty/serial/8250/8250_core.c | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/drivers/tty/serial/8250/8250_core.c b/drivers/tty/serial/8250/8250_core.c
> index 3912646..8f292da 100644
> --- a/drivers/tty/serial/8250/8250_core.c
> +++ b/drivers/tty/serial/8250/8250_core.c
> @@ -395,6 +395,12 @@ static void serial8250_release_rsa_resource(struct uart_8250_port *up)
> }
> }
> #endif
> +static int serial8250_rs485_config(struct uart_port *port,
> + struct serial_rs485 *rs485)
> +{
> + port->rs485 = *rs485;
> + return 0;
> +}
>
> static const struct uart_ops *base_ops;
> static struct uart_ops univ8250_port_ops;
> @@ -990,6 +996,10 @@ int serial8250_register_8250_port(struct uart_8250_port *up)
> uart->port.rs485 = up->port.rs485;
> uart->dma = up->dma;
>
> + /* Use software RS485 support when hardware one is not available */
> + if (!(uart->capabilities & UART_CAP_HW485) && !uart->port.rs485_config)
> + uart->port.rs485_config = serial8250_rs485_config;
To setup a default 8250 port function,
1. define the default 8250 port function in 8250/8250_port.c
2. add the port function to the dispatch table (serial8250_pops)
3. add a test for 8250 sub-driver override in serial8250_register_8250_port()
Eg.,
if (up->port.rs485_config)
uart->port.rs485_config = up->port.rs485_config;
Regards,
Peter Hurley
> /* Take tx_loadsz from fifosize if it wasn't set separately */
> if (uart->port.fifosize && !uart->tx_loadsz)
> uart->tx_loadsz = uart->port.fifosize;
>
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
