Hi Peter.
2015-10-21 21:46 GMT+09:00 Peter Hurley <peter@xxxxxxxxxxxxxxxxxx>:
> On 10/21/2015 04:58 AM, Sudeep Holla wrote:
>> On 21/10/15 06:09, Masahiro Yamada wrote:
>>> I think there exist two ways to specify the console port and baudrate.
>>>
>>>
>>> [1] Specify console in bootargs
>>>
>>> chosen {
>>> bootargs = "console=ttyS0,115200";
>>> };
>>>
>>>
>>> [2] Specify stdout-path
>>>
>>> chosen {
>>> stdout-path = "serial0:115200n8";
>>
>> This will work for even early/boot console, so this is better than
>> option [1]
>
> Be aware that options specified via /chosen/stdout-path are
> currently ignored by earlycon. There were some hiccups getting the
> initial support upstream; when 4.4 hits mainline, I'll resubmit
> my series that implements the of_serial i/o properties and
> options passthrough to earlycon setup.
As I said in another thread ("serial: earlycon: allow to specify
uartclk in earlycon kernel-parameter"),
stdout-path can pass dev->baud, but not port->uartclk.
It is usually specified "clocks" phandle, but
clk is not ready at the point of earlycon.
It seems impossible to set up the baudrate even if the options are passed.
--
Best Regards
Masahiro Yamada
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
