Reformat, grammar improvements, use "ms" instead of "msec".
Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
v3:
- No changes,
v2:
- New.
---
drivers/tty/serial/sh-sci.c | 14 +++++++-------
1 file changed, 7 insertions(+), 7 deletions(-)
diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c
index 340700a11b152952..cfef543df25271f5 100644
--- a/drivers/tty/serial/sh-sci.c
+++ b/drivers/tty/serial/sh-sci.c
@@ -2015,13 +2015,13 @@ static void sci_set_termios(struct uart_port *port, struct ktermios *termios,
#ifdef CONFIG_SERIAL_SH_SCI_DMA
/*
* Calculate delay for 2 DMA buffers (4 FIFO).
- * See serial_core.c::uart_update_timeout(). With 10
- * bits (CS8), 250Hz, 115200 baud and 64 bytes FIFO, the above function
- * calculates 1 jiffie for the data plus 5 jiffies for the "slop(e)."
- * Then below we calculate 5 jiffies (20ms) for 2 DMA buffers (4 FIFO
- * sizes), but when performing a faster transfer, value obtained by
- * this formula is may not enough. Therefore, if value is smaller than
- * 20msec, this sets 20msec as timeout of DMA.
+ * See serial_core.c::uart_update_timeout().
+ * With 10 bits (CS8), 250Hz, 115200 baud and 64 bytes FIFO, the above
+ * function calculates 1 jiffie for the data plus 5 jiffies for the
+ * "slop(e)." Then below we calculate 5 jiffies (20ms) for 2 DMA
+ * buffers (4 FIFO sizes), but when performing a faster transfer, the
+ * value obtained by this formula is too small. Therefore, if the value
+ * is smaller than 20ms, use 20ms as the timeout value for DMA.
*/
if (s->chan_rx) {
unsigned int bits;
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
