The DMA is a function 0 of the multifunction device where SPI host is attached. Thus, we may avoid to hardcode PCI slot number. Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> --- drivers/tty/serial/pch_uart.c | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-) diff --git a/drivers/tty/serial/pch_uart.c b/drivers/tty/serial/pch_uart.c index 2f06e5a..ea4ffc2 100644 --- a/drivers/tty/serial/pch_uart.c +++ b/drivers/tty/serial/pch_uart.c @@ -736,9 +736,10 @@ static void pch_request_dma(struct uart_port *port) dma_cap_zero(mask); dma_cap_set(DMA_SLAVE, mask); - dma_dev = pci_get_bus_and_slot(priv->pdev->bus->number, - PCI_DEVFN(0xa, 0)); /* Get DMA's dev - information */ + /* Get DMA's dev information */ + dma_dev = pci_get_slot(priv->pdev->bus, + PCI_DEVFN(PCI_SLOT(priv->pdev->devfn), 0)); + /* Set Tx DMA */ param = &priv->param_tx; param->dma_dev = &dma_dev->dev; -- 2.0.1 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
