A comment states, that, according to the data sheet, to enable interrupts the disable register should be written, but the enable register could be left untouched. And it suspsects a HW bug requiring to write both. Reviewing the data sheet, these statements seem wrong. Just as one would expect. Writing to the enable/disable register enables/disables interrupts. Hence the misleading comment and needless write to the disable register are removed from the enable sequence. Signed-off-by: Soren Brinkmann <soren.brinkmann@xxxxxxxxxx> --- I added a few lines to comment the change and altered the summary line. In case this causes issues it should show up a little easier as a candidate to revert. Sören --- drivers/tty/serial/xilinx_uartps.c | 6 +----- 1 file changed, 1 insertion(+), 5 deletions(-) diff --git a/drivers/tty/serial/xilinx_uartps.c b/drivers/tty/serial/xilinx_uartps.c index b182ab8cfd07..f9a2c2fc03c4 100644 --- a/drivers/tty/serial/xilinx_uartps.c +++ b/drivers/tty/serial/xilinx_uartps.c @@ -1085,11 +1085,7 @@ static void xuartps_console_write(struct console *co, const char *s, xuartps_writel(ctrl, XUARTPS_CR_OFFSET); - /* restore interrupt state, it seems like there may be a h/w bug - * in that the interrupt enable register should not need to be - * written based on the data sheet - */ - xuartps_writel(~imr, XUARTPS_IDR_OFFSET); + /* restore interrupt state */ xuartps_writel(imr, XUARTPS_IER_OFFSET); if (locked) -- 1.9.0.1.g4196000 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html