Sourav Poddar <sourav.poddar@xxxxxx> writes:
> Hi Kevin,
> On Friday 05 April 2013 11:10 PM, Kevin Hilman wrote:
>> Sourav Poddar<sourav.poddar@xxxxxx> writes:
>>
>>> With dt boot, uart wakeup after suspend is non functional while using
>>> "no_console_suspend" in the bootargs. With "no_console_suspend" used, we
>>> should prevent the runtime suspend of the uart port which is getting used
>>> as an console.
>>>
>>> Cc: Santosh Shilimkar<santosh.shilimkar@xxxxxx>
>>> Cc: Felipe Balbi<balbi@xxxxxx>
>>> Cc: Rajendra nayak<rnayak@xxxxxx>
>>> Tested on omap5430evm, omap4430sdp.
>>>
>>> Signed-off-by: Sourav Poddar<sourav.poddar@xxxxxx>
>> Rather than make these special checks inside the driver's runtime PM
>> callbacks, you should just disable runtime PM (pm_runtime_disable())
>>
>> Then, this should be broken into 2 patches.
>>
>> 1) serial core: add the '->is_console' flag. (nit on naming: don't call
>> it port_is_console, since the struct is already a uart_port)
>>
>> 2) In the OMAP UART driver's ->prepare callback, check the is_console flag
>> and pm_runtime_disable() accordingly (then pm_runtime_enable() in
>> the drivers's ->complete callback.
>>
>> Kevin
>
> I was working on your above suggestions, but realised there is not
> only console
> uart which has the requirement of keeping the clocks enabled while going on
> suspend.
>
> If you see arch/arm/boot/dts/am33xx.dtsi, there is a ocmcram which has
> "no_idle_on_suspend" property used.
Can you please ask the AM33xx folks how (and why) this is being used?
I don't see/find a driver for this device in mainline, so without a
driver this flag will not be used.
> ocmcram: ocmcram@40300000 {
> compatible = "ti,am3352-ocmcram";
> reg = <0x40300000 0x10000>;
> ti,hwmods = "ocmcram";
> ti,no_idle_on_suspend;
> };
> This property gets checked in omap_device file and correspondingly
> od->flags is set.
>
> Based on your above inputs, the patches which I cooked up is
> inlined[1]. Though, the below
> patches works fine for uart case. The patches will effect ocmcram case
> and I am inling them
> "just for discussion".
Could you also have a look at Russell's suggestion for getting rid of
the 'is_console' flag.
Thanks,
Kevin
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
