We add the capabilty to probe Renesas SCI devices using Device Tree setup. Signed-off-by: Bastian Hecht <hechtb+renesas@xxxxxxxxx> --- v4: Added missing OF header .../bindings/tty/serial/renesas,sci-serial.txt | 53 ++++++++ drivers/tty/serial/sh-sci.c | 127 +++++++++++++++++++- include/linux/serial_sci.h | 4 + 3 files changed, 180 insertions(+), 4 deletions(-) create mode 100644 Documentation/devicetree/bindings/tty/serial/renesas,sci-serial.txt diff --git a/Documentation/devicetree/bindings/tty/serial/renesas,sci-serial.txt b/Documentation/devicetree/bindings/tty/serial/renesas,sci-serial.txt new file mode 100644 index 0000000..6ad1adf --- /dev/null +++ b/Documentation/devicetree/bindings/tty/serial/renesas,sci-serial.txt @@ -0,0 +1,53 @@ +* Renesas SH-Mobile Serial Communication Interface + +Required properties: +- compatible : Should be "renesas,sci-<port type>-uart", where <port type> may be + SCI, SCIF, IRDA, SCIFA or SCIFB. +- reg : Address and length of the register set for the device +- interrupts : Should contain the following IRQs: ERI, RXI, TXI and BRI. +- cell-index : The device id. +- renesas,scscr : Should contain a bitfield used by the Serial Control Register. + b7 = SCSCR_TIE + b6 = SCSCR_RIE + b5 = SCSCR_TE + b4 = SCSCR_RE + b3 = SCSCR_REIE + b2 = SCSCR_TOIE + b1 = SCSCR_CKE1 + b0 = SCSCR_CKE0 +- renesas,scbrr-algo-id : Algorithm ID for the Bit Rate Register + 1 = SCBRR_ALGO_1 ((clk + 16 * bps) / (16 * bps) - 1) + 2 = SCBRR_ALGO_2 ((clk + 16 * bps) / (32 * bps) - 1) + 3 = SCBRR_ALGO_3 (((clk * 2) + 16 * bps) / (16 * bps) - 1) + 4 = SCBRR_ALGO_4 (((clk * 2) + 16 * bps) / (32 * bps) - 1) + 5 = SCBRR_ALGO_5 (((clk * 1000 / 32) / bps) - 1) + +Optional properties: +- renesas,autoconf : Set if device is capable of auto configuration +- renesas,regtype : Overwrite the register layout. In most cases you can rely + on auto-probing (omit this property or set to 0) but some legacy devices + use a non-default register layout. Possible layouts are + 0 = SCIx_PROBE_REGTYPE (default) + 1 = SCIx_SCI_REGTYPE + 2 = SCIx_IRDA_REGTYPE + 3 = SCIx_SCIFA_REGTYPE + 4 = SCIx_SCIFB_REGTYPE + 5 = SCIx_SH2_SCIF_FIFODATA_REGTYPE + 6 = SCIx_SH3_SCIF_REGTYPE + 7 = SCIx_SH4_SCIF_REGTYPE + 8 = SCIx_SH4_SCIF_NO_SCSPTR_REGTYPE + 9 = SCIx_SH4_SCIF_FIFODATA_REGTYPE + 10 = SCIx_SH7705_SCIF_REGTYPE + + +Example: + sci@0xe6c50000 { + compatible = "renesas,sci-SCIFA-uart"; + interrupt-parent = <&intca>; + reg = <0xe6c50000 0x100>; + interrupts = <0x0c20>, <0x0c20>, <0x0c20>, <0x0c20>; + cell-index = <1>; + renesas,scscr = <0x30>; + renesas,scbrr-algo-id = <4>; + renesas,autoconf; + }; diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c index 6147756..cc1b69c 100644 --- a/drivers/tty/serial/sh-sci.c +++ b/drivers/tty/serial/sh-sci.c @@ -52,6 +52,7 @@ #include <linux/scatterlist.h> #include <linux/slab.h> #include <linux/gpio.h> +#include <linux/of.h> #ifdef CONFIG_SUPERH #include <asm/sh_bios.h> @@ -2353,6 +2354,112 @@ static int sci_remove(struct platform_device *dev) return 0; } +#ifdef CONFIG_OF +static const struct of_device_id of_sci_match[] = { + { .compatible = "renesas,sci-SCI-uart", + .data = (void *)PORT_SCI }, + { .compatible = "renesas,sci-SCIF-uart", + .data = (void *)PORT_SCIF }, + { .compatible = "renesas,sci-IRDA-uart", + .data = (void *)PORT_IRDA }, + { .compatible = "renesas,sci-SCIFA-uart", + .data = (void *)PORT_SCIFA }, + { .compatible = "renesas,sci-SCIFB-uart", + .data = (void *)PORT_SCIFB }, + {}, +}; +MODULE_DEVICE_TABLE(of, of_sci_match); + +static struct plat_sci_port *sci_parse_dt(struct platform_device *pdev, + int *dev_id) +{ + struct plat_sci_port *p; + struct device_node *np = pdev->dev.of_node; + const struct of_device_id *match; + struct resource *res; + const __be32 *prop; + int i, irq, val; + + match = of_match_node(of_sci_match, pdev->dev.of_node); + if (!match || !match->data) { + dev_err(&pdev->dev, "OF match error\n"); + return NULL; + } + + p = devm_kzalloc(&pdev->dev, sizeof(struct plat_sci_port), GFP_KERNEL); + if (!p) { + dev_err(&pdev->dev, "failed to allocate DT config data\n"); + return NULL; + } + + res = platform_get_resource(pdev, IORESOURCE_MEM, 0); + if (!res) { + dev_err(&pdev->dev, "failed to get I/O memory\n"); + return NULL; + } + p->mapbase = res->start; + + for (i = 0; i < SCIx_NR_IRQS; i++) { + irq = platform_get_irq(pdev, i); + if (irq < 0) { + dev_err(&pdev->dev, "failed to get irq data %d\n", i); + return NULL; + } + p->irqs[i] = irq; + } + + prop = of_get_property(np, "cell-index", NULL); + if (!prop) { + dev_err(&pdev->dev, "required DT prop cell-index missing\n"); + return NULL; + } + *dev_id = be32_to_cpup(prop); + + prop = of_get_property(np, "renesas,scscr", NULL); + if (!prop) { + dev_err(&pdev->dev, "required DT prop scscr missing\n"); + return NULL; + } + p->scscr = be32_to_cpup(prop); + + prop = of_get_property(np, "renesas,scbrr-algo-id", NULL); + if (!prop) { + dev_err(&pdev->dev, "required DT prop scbrr-algo-id missing\n"); + return NULL; + } + val = be32_to_cpup(prop); + if (val <= SCBRR_ALGO_INVALID || val >= SCBRR_NR_ALGOS) { + dev_err(&pdev->dev, "DT prop scbrr-algo-id out of range\n"); + return NULL; + } + p->scbrr_algo_id = val; + + p->flags = UPF_IOREMAP; + if (of_get_property(np, "renesas,autoconf", NULL)) + p->flags |= UPF_BOOT_AUTOCONF; + + prop = of_get_property(np, "renesas,regtype", NULL); + if (prop) { + val = be32_to_cpup(prop); + if (val < SCIx_PROBE_REGTYPE || val >= SCIx_NR_REGTYPES) { + dev_err(&pdev->dev, "DT prop regtype out of range\n"); + return NULL; + } + p->regtype = val; + } + + p->type = (unsigned int)match->data; + + return p; +} +#else +static struct plat_sci_port *sci_parse_dt(struct platform_device *pdev, + int *dev_id) +{ + return NULL; +} +#endif /* CONFIG_OF */ + static int sci_probe_single(struct platform_device *dev, unsigned int index, struct plat_sci_port *p, @@ -2385,9 +2492,9 @@ static int sci_probe_single(struct platform_device *dev, static int sci_probe(struct platform_device *dev) { - struct plat_sci_port *p = dev->dev.platform_data; - struct sci_port *sp = &sci_ports[dev->id]; - int ret; + struct plat_sci_port *p; + struct sci_port *sp; + int ret, dev_id = dev->id; /* * If we've come here via earlyprintk initialization, head off to @@ -2397,9 +2504,20 @@ static int sci_probe(struct platform_device *dev) if (is_early_platform_device(dev)) return sci_probe_earlyprintk(dev); + if (dev->dev.of_node) + p = sci_parse_dt(dev, &dev_id); + else + p = dev->dev.platform_data; + + if (!p) { + dev_err(&dev->dev, "no setup data supplied\n"); + return -EINVAL; + } + + sp = &sci_ports[dev_id]; platform_set_drvdata(dev, sp); - ret = sci_probe_single(dev, dev->id, p, sp); + ret = sci_probe_single(dev, dev_id, p, sp); if (ret) return ret; @@ -2451,6 +2569,7 @@ static struct platform_driver sci_driver = { .name = "sh-sci", .owner = THIS_MODULE, .pm = &sci_dev_pm_ops, + .of_match_table = of_match_ptr(of_sci_match), }, }; diff --git a/include/linux/serial_sci.h b/include/linux/serial_sci.h index eb763ad..857eec4 100644 --- a/include/linux/serial_sci.h +++ b/include/linux/serial_sci.h @@ -11,11 +11,15 @@ #define SCIx_NOT_SUPPORTED (-1) enum { + SCBRR_ALGO_INVALID, + SCBRR_ALGO_1, /* ((clk + 16 * bps) / (16 * bps) - 1) */ SCBRR_ALGO_2, /* ((clk + 16 * bps) / (32 * bps) - 1) */ SCBRR_ALGO_3, /* (((clk * 2) + 16 * bps) / (16 * bps) - 1) */ SCBRR_ALGO_4, /* (((clk * 2) + 16 * bps) / (32 * bps) - 1) */ SCBRR_ALGO_5, /* (((clk * 1000 / 32) / bps) - 1) */ + + SCBRR_NR_ALGOS, }; #define SCSCR_TIE (1 << 7) -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html