Take advantage of the switch to mode B for accessing the TCR register,
and move the xon/xoff configuration there. This allows further
simplication of this sequence.
Signed-off-by: Russell King <rmk+kernel@xxxxxxxxxxxxxxxx>
---
drivers/tty/serial/omap-serial.c | 13 +++++++------
1 files changed, 7 insertions(+), 6 deletions(-)
diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index 22877ac..e786eac 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -871,16 +871,20 @@ serial_omap_set_termios(struct uart_port *port, struct ktermios *termios,
else
serial_out(up, UART_OMAP_MDR1, up->mdr1);
- /* Enable access to TCR/TLR */
+ /* Configure flow control */
serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B);
+
+ /* XON1/XOFF1 accessible mode B, TCRTLR=0, ECB=0 */
+ serial_out(up, UART_XON1, termios->c_cc[VSTART]);
+ serial_out(up, UART_XOFF1, termios->c_cc[VSTOP]);
+
+ /* Enable access to TCR/TLR */
serial_out(up, UART_EFR, up->efr | UART_EFR_ECB);
serial_out(up, UART_LCR, UART_LCR_CONF_MODE_A);
serial_out(up, UART_MCR, up->mcr | UART_MCR_TCRTLR);
serial_out(up, UART_TI752_TCR, OMAP_UART_TCR_TRIG);
- /* Hardware Flow Control Configuration */
-
if (termios->c_cflag & CRTSCTS) {
/* Enable AUTORTS and AUTOCTS */
up->efr |= UART_EFR_CTS | UART_EFR_RTS;
@@ -897,9 +901,6 @@ serial_omap_set_termios(struct uart_port *port, struct ktermios *termios,
serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B);
serial_out(up, UART_EFR, up->efr);
- serial_out(up, UART_XON1, termios->c_cc[VSTART]);
- serial_out(up, UART_XOFF1, termios->c_cc[VSTOP]);
-
/* clear SW control mode bits */
up->efr &= OMAP_UART_SW_CLR;
--
1.7.4.4
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
