Intel EG20T PCH has UART device which is compatible with 8250. Currently, with general configuration, the PCH UART driver is not loaded but 8250 standard driver is loaded. Therefore, in case of using PCH UART driver, need to disable 8250 pci function. However, this procedure is not best solution. This patch, in 8250_pci, if the device is the PCH or the family IOH, '-ENODEV' is returned. As a result, disabling 8250-pci processing becomes unnecessary. Signed-off-by: Tomoya MORINAGA <tomoya-linux@xxxxxxxxxxxxxxx> --- drivers/tty/serial/8250_pci.c | 13 +++++++++++++ 1 files changed, 13 insertions(+), 0 deletions(-) diff --git a/drivers/tty/serial/8250_pci.c b/drivers/tty/serial/8250_pci.c index 738cec9..2678d9d 100644 --- a/drivers/tty/serial/8250_pci.c +++ b/drivers/tty/serial/8250_pci.c @@ -2559,6 +2559,19 @@ pciserial_init_one(struct pci_dev *dev, const struct pci_device_id *ent) return -EINVAL; } +#if defined(CONFIG_SERIAL_PCH_UART) || defined(CONFIG_SERIAL_PCH_UART_MODULE) + if ((dev->vendor == PCI_VENDOR_ID_INTEL && dev->device == 0x8811) || + (dev->vendor == PCI_VENDOR_ID_INTEL && dev->device == 0x8812) || + (dev->vendor == PCI_VENDOR_ID_INTEL && dev->device == 0x8813) || + (dev->vendor == PCI_VENDOR_ID_INTEL && dev->device == 0x8814) || + (dev->vendor == 0x10DB && dev->device == 0x8027) || + (dev->vendor == 0x10DB && dev->device == 0x8028) || + (dev->vendor == 0x10DB && dev->device == 0x8029) || + (dev->vendor == 0x10DB && dev->device == 0x800C) || + (dev->vendor == 0x10DB && dev->device == 0x800D)) + return -ENODEV; +#endif + board = &pci_boards[ent->driver_data]; rc = pci_enable_device(dev); -- 1.7.4 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
