From: "Matthew R. Ochs" <mrochs@xxxxxxxxxxxxxxxxxx>
The EEH reset handler is ignorant to the current state of the
driver when processing a frozen event and initiating a device
reset. This can be an issue if an EEH event occurs while a user
or stack initiated reset is executing. More specifically, if an
EEH occurs while the SCSI host reset handler is active, the reset
initiated by the EEH thread will likely collide with the host reset
thread. This can leave the device in an inconsistent state, or worse,
cause a system crash.
As a remedy, the EEH handler is updated to evaluate the device state
and take appropriate action (proceed, wait, or disconnect host). The
host reset handler is also updated to handle situations where an EEH
occurred during a host reset. In such situations, the host reset handler
will delay reporting back a success to give the EEH reset an opportunity
to complete.
Signed-off-by: Matthew R. Ochs <mrochs@xxxxxxxxxxxxxxxxxx>
---
drivers/scsi/cxlflash/main.c | 15 ++++++++++++++-
1 file changed, 14 insertions(+), 1 deletion(-)
diff --git a/drivers/scsi/cxlflash/main.c b/drivers/scsi/cxlflash/main.c
index 4c2559a..4ef5235 100644
--- a/drivers/scsi/cxlflash/main.c
+++ b/drivers/scsi/cxlflash/main.c
@@ -2042,6 +2042,11 @@ retry:
* cxlflash_eh_host_reset_handler() - reset the host adapter
* @scp: SCSI command from stack identifying host.
*
+ * Following a reset, the state is evaluated again in case an EEH occurred
+ * during the reset. In such a scenario, the host reset will either yield
+ * until the EEH recovery is complete or return success or failure based
+ * upon the current device state.
+ *
* Return:
* SUCCESS as defined in scsi/scsi.h
* FAILED as defined in scsi/scsi.h
@@ -2074,7 +2079,8 @@ static int cxlflash_eh_host_reset_handler(struct scsi_cmnd *scp)
} else
cfg->state = STATE_NORMAL;
wake_up_all(&cfg->reset_waitq);
- break;
+ ssleep(1);
+ /* fall through */
case STATE_RESET:
wait_event(cfg->reset_waitq, cfg->state != STATE_RESET);
if (cfg->state == STATE_NORMAL)
@@ -2590,6 +2596,9 @@ out_remove:
* @pdev: PCI device struct.
* @state: PCI channel state.
*
+ * When an EEH occurs during an active reset, wait until the reset is
+ * complete and then take action based upon the device state.
+ *
* Return: PCI_ERS_RESULT_NEED_RESET or PCI_ERS_RESULT_DISCONNECT
*/
static pci_ers_result_t cxlflash_pci_error_detected(struct pci_dev *pdev,
@@ -2603,6 +2612,10 @@ static pci_ers_result_t cxlflash_pci_error_detected(struct pci_dev *pdev,
switch (state) {
case pci_channel_io_frozen:
+ wait_event(cfg->reset_waitq, cfg->state != STATE_RESET);
+ if (cfg->state == STATE_FAILTERM)
+ return PCI_ERS_RESULT_DISCONNECT;
+
cfg->state = STATE_RESET;
scsi_block_requests(cfg->host);
drain_ioctls(cfg);
--
2.1.0
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
