Hi Dan,
On 12/16/15, 3:07 AM, "linux-scsi-owner@xxxxxxxxxxxxxxx on behalf of Dan
Carpenter" <linux-scsi-owner@xxxxxxxxxxxxxxx on behalf of
dan.carpenter@xxxxxxxxxx> wrote:
>After the loop we test for "if (!retries) " as a failure, but actually
>the post-op here will end with retries set to -1. I have fixed this by
>using a pre-op instead.
>
>Fixes: 7ec0effd30bb ('[SCSI] qla2xxx: Add support for ISP8044.')
>Signed-off-by: Dan Carpenter <dan.carpenter@xxxxxxxxxx>
>
>diff --git a/drivers/scsi/qla2xxx/qla_nx2.c
>b/drivers/scsi/qla2xxx/qla_nx2.c
>index 007192d..66d629e 100644
>--- a/drivers/scsi/qla2xxx/qla_nx2.c
>+++ b/drivers/scsi/qla2xxx/qla_nx2.c
>@@ -3491,7 +3491,7 @@ qla8044_poll_flash_status_reg(struct scsi_qla_host
>*vha)
> int retries = QLA8044_FLASH_READ_RETRY_COUNT;
> int ret_val = QLA_SUCCESS;
>
>- while (retries--) {
>+ while (--retries) {
> ret_val = qla8044_rd_reg_indirect(vha, QLA8044_FLASH_STATUS,
> &flash_status);
> if (ret_val) {
There is flaw in this pre-decrement logic here for following 2 reasons
1. The pre-decrement reduces the total number of retries by one
2. If the retries is already Zero, then the pre-decrement would cause loop
to iterate for a very large number of times.
The correct fix for this would be to change the if(!retries) to if
(retries == -1) or if (retries < 0)
We¹ll send a follow up patch to fix this.
Thanks,
Himanshu
>--
>To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
>the body of a message to majordomo@xxxxxxxxxxxxxxx
>More majordomo info at http://vger.kernel.org/majordomo-info.html
<<attachment: winmail.dat>>
