Re: [PATCH 1/4] target/core: T10-Dif: check HW support capabilities

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Answer in line.

Regards,
Quinn Tran




On 3/28/14 5:05 PM, "sagi grimberg" <sagig@xxxxxxxxxxxx> wrote:

>On 3/29/2014 2:05 AM, Quinn Tran wrote:
>> Check lower layer/HW support of T10-dif capability.
>> When the LUN is linked between the underlining fabric
>> and back end device, the Protection Type(1,2,3) is
>> check against each other to make sure both side are
>> capable of supporting the same protection setting.
>>
>> ln -s /sys/kernel/config/target/core/rd_mcp_0/q_tcm_mcp.0
>> /sys/kernel/config/target/qla2xxx/$L_WWPN/tpgt_1/lun/lun_0/tcm_123
>>
>> Signed-off-by: Nicholas Bellinger <nab@xxxxxxxxxxxxxxx>
>> Signed-off-by: Giridhar Malavali <giridhar.malavali@xxxxxxxxxx>
>> ---
>>   drivers/target/target_core_fabric_configfs.c | 20 ++++++++++++++++++++
>>   drivers/target/target_core_tpg.c             |  9 +++++++++
>>   include/target/target_core_base.h            | 14 ++++++++++++++
>>   include/target/target_core_fabric.h          |  1 +
>>   4 files changed, 44 insertions(+)
>>
>> diff --git a/drivers/target/target_core_fabric_configfs.c
>>b/drivers/target/target_core_fabric_configfs.c
>> index 7de9f04..3ce07ec 100644
>> --- a/drivers/target/target_core_fabric_configfs.c
>> +++ b/drivers/target/target_core_fabric_configfs.c
>> @@ -777,6 +777,26 @@ static int target_fabric_port_link(
>>                              struct se_portal_group, tpg_group);
>>      tf = se_tpg->se_tpg_wwn->wwn_tf;
>>
>> +
>> +    if (dev->dev_attrib.pi_prot_type) {
>> +            uint32_t cap[] = { 0,
>> +                               TARGET_DIF_TYPE1_PROTECTION,
>> +                               TARGET_DIF_TYPE2_PROTECTION,
>> +                               TARGET_DIF_TYPE3_PROTECTION};
>> +            uint32_t pt_bits = cap[dev->dev_attrib.pi_prot_type];
>> +            pt_bits &= se_tpg->fabric_sup_prot_type;
>
>At what point should the fabric fill that? it can vary between portals
>right?

QT> Yes, protection mode can vary between portals. When user select the
physical function (via fabric_make_tpg), you know the specific portal
based on user input and its capability. This is where Qlogic register its
capabilities based on specific hardware.


>I would prefer to do that as a function pointer to explicitly ask the
>fabric it's support.

QT> is it still require with previous answer ?


>
>> +
>> +            /* cross check with fabric to see if t10dif is supported */
>> +            if (!pt_bits) {
>> +                    //dev->dev_attrib.pi_prot_type = 0;
>
>Probably should lose the comment.

<nod>

>
>> +                    pr_err("dev[%p]: DIF protection mismatch with fabric "
>> +                            "(%s). Transport capability bits[0x%x]\n",
>> +                            dev, se_tpg->se_tpg_wwn->wwn_group.cg_item.ci_name,
>> +                            se_tpg->fabric_sup_prot_type);
>> +                    return -EFAULT;
>
>Didn't we agree that this is allowed and the target core should
>compensate on the lack fabric support?

<QT> My recollection was that it's not recommended to have different
portals with different supported feature. Meaning a SCSI Write without Dif
down a none-T10PI portal update the data.  The Guard on the disk is now
mismatch with the data. A SCSI Read down a T10PI path will run into a
Guard failure.

By introducing this option, Disk vendor require additional logic to
compensate for this. I think it's cheaper to have supported hardware
rather than support nightmare.

>
>> +            }
>> +    }
>> +
>>      if (lun->lun_se_dev !=  NULL) {
>>              pr_err("Port Symlink already exists\n");
>>              return -EEXIST;
>> diff --git a/drivers/target/target_core_tpg.c
>>b/drivers/target/target_core_tpg.c
>> index c036595..9279971 100644
>> --- a/drivers/target/target_core_tpg.c
>> +++ b/drivers/target/target_core_tpg.c
>> @@ -632,6 +632,15 @@ int core_tpg_set_initiator_node_tag(
>>   }
>>   EXPORT_SYMBOL(core_tpg_set_initiator_node_tag);
>>
>> +void core_tpg_set_fabric_t10dif(
>> +    struct se_portal_group *tpg,
>> +    uint32_t fabric_t10dif_force_on)
>> +{
>> +    tpg->fabric_t10dif_force_on = fabric_t10dif_force_on;
>> +}
>> +EXPORT_SYMBOL(core_tpg_set_fabric_t10dif);
>> +
>
>Is there a user for this function in this patch?

QT> I'm on the fence with this piece.  Just thinking of a case where DIX
is not available for initiator side, but user wants to turn on protection
at the link layer.  Our test folks would like to cover this case in the
future.

>
>> +
>>   static void core_tpg_lun_ref_release(struct percpu_ref *ref)
>>   {
>>      struct se_lun *lun = container_of(ref, struct se_lun, lun_ref);
>> diff --git a/include/target/target_core_base.h
>>b/include/target/target_core_base.h
>> index ec3e3a3..fc2c0ef 100644
>> --- a/include/target/target_core_base.h
>> +++ b/include/target/target_core_base.h
>> @@ -241,6 +241,17 @@ enum tcm_tmrsp_table {
>>      TMR_FUNCTION_REJECTED           = 5,
>>   };
>>
>> +enum target_guard_type_cap {
>> +    TARGET_GUARD_CRC = 1 << 0,
>> +    TARGET_GUARD_IP  = 1 << 1,
>> +};
>> +
>
>So this was dropped in previous rounds, this is more of an initiator
>thing, the target will always
>receive CRC from the wire and will pass it to the backing device so no
>need to convert to IP_CSUM.


QT> Will drop this.


>
>> +enum target_prot_type_cap {
>> +    TARGET_DIF_TYPE1_PROTECTION = 1 << 0, /* T10 DIF Type 1 */
>> +    TARGET_DIF_TYPE2_PROTECTION = 1 << 1, /* T10 DIF Type 2 */
>> +    TARGET_DIF_TYPE3_PROTECTION = 1 << 2, /* T10 DIF Type 3 */
>> +};
>> +
>>   /*
>>    * Used for target SCSI statistics
>>    */
>> @@ -862,6 +873,9 @@ struct se_portal_group {
>>      enum transport_tpg_type_table se_tpg_type;
>>      /* Number of ACLed Initiator Nodes for this TPG */
>>      u32                     num_node_acls;
>> +    u32                     fabric_t10dif_force_on;
>> +    u32                     fabric_sup_guard_type;
>> +    u32                     fabric_sup_prot_type;
>>      /* Used for PR SPEC_I_PT=1 and REGISTER_AND_MOVE */
>>      atomic_t                tpg_pr_ref_count;
>>      /* Spinlock for adding/removing ACLed Nodes */
>> diff --git a/include/target/target_core_fabric.h
>>b/include/target/target_core_fabric.h
>> index 1d10436..4c3dab5 100644
>> --- a/include/target/target_core_fabric.h
>> +++ b/include/target/target_core_fabric.h
>> @@ -152,6 +152,7 @@ int      core_tpg_set_initiator_node_queue_depth(struct
>>se_portal_group *,
>>              unsigned char *, u32, int);
>>   int        core_tpg_set_initiator_node_tag(struct se_portal_group *,
>>              struct se_node_acl *, const char *);
>> +void        core_tpg_set_fabric_t10dif(struct se_portal_group *, uint32_t);
>>   int        core_tpg_register(struct target_core_fabric_ops *, struct se_wwn
>>*,
>>              struct se_portal_group *, void *, int);
>>   int        core_tpg_deregister(struct se_portal_group *);
>


________________________________

This message and any attached documents contain information from QLogic Corporation or its wholly-owned subsidiaries that may be confidential. If you are not the intended recipient, you may not read, copy, distribute, or use this information. If you have received this transmission in error, please notify the sender immediately by reply e-mail and then delete this message.

<<attachment: winmail.dat>>


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Index of Archives]     [SCSI Target Devel]     [Linux SCSI Target Infrastructure]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Linux IIO]     [Samba]     [Device Mapper]
  Powered by Linux