Hi Niall, Please update the firmware from http://www.adaptec.com/en-us/support/sas/#sas_raid Adaptec Series 7 SAS/SATA 6 Gb - Host Bus Adapter section based on your card. What is the current firmware version? You can get from the sys file "fw_version" under /sys/devices. Can you please try checking with different pm80xx HBA card if you have? Regards, Suresh -----Original Message----- From: linux-scsi-owner@xxxxxxxxxxxxxxx [mailto:linux-scsi-owner@xxxxxxxxxxxxxxx] On Behalf Of Niall Drievers Sent: Tuesday, December 10, 2013 2:51 PM To: linux-scsi@xxxxxxxxxxxxxxx Subject: pm8001 issue Hi, I've recently been trying install Linux on to a piece of hardware I picked up and I've noticed this error in the dmesg output when the kernel is loading. The error can be produced in version 0.1.36 and 0.1.37 of the pm8001 module. I was hoping that when I updated it, I might be able to resolve it, but alas. My knowledge of MPI is rather limited and I was hoping someone might be able to point me in the right direction with regards to tackling this... increasing the max wait count, changing the firmware, etc? [ 23.874307] mpi_uninit_check 663:TIMEOUT:IBDB value/=0x2 [ 23.937847] soft_reset_ready_check 697:MPI state is not ready [ 24.006578] pm8001_chip_soft_rst 761:FW is not ready [ 26.449013] pm8001_chip_init 609:Firmware is not ready! Regards, Niall -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
