When SCSI command is received with task attribute not set, set it to SIMPLE. Previously it is set to untagged. This causes the firmware to fail the commands. Signed-off-by: Sreekanth Reddy <Sreekanth.Reddy@xxxxxxx> --- diff --git a/drivers/scsi/mpt2sas/mpt2sas_scsih.c b/drivers/scsi/mpt2sas/mpt2sas_scsih.c index 014caef..3b150b8 100644 --- a/drivers/scsi/mpt2sas/mpt2sas_scsih.c +++ b/drivers/scsi/mpt2sas/mpt2sas_scsih.c @@ -3998,11 +3998,7 @@ _scsih_qcmd_lck(struct scsi_cmnd *scmd, void (*done)(struct scsi_cmnd *)) else mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ; } else -/* MPI Revision I (UNIT = 0xA) - removed MPI2_SCSIIO_CONTROL_UNTAGGED */ -/* mpi_control |= MPI2_SCSIIO_CONTROL_UNTAGGED; - */ - mpi_control |= (0x500); - + mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ; } else mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ; /* Make sure Device is not raid volume. -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
