>> [ 174.758218] scsi_remove_target[0]: reap 0:0 state: 2 reap: 1 dev_del: 1
>
> Thanks! Does the attached patch fix the issue for you?
>
That worked!
[ 169.402990] netconsole: network logging started
[ 200.903700] mptbase: ioc0: LogInfo(0x31110d00): Originator={PL},
Code={Reset}, SubCode(0x0d00) cb_idx mptbase_reply
[ 205.173793] sd 0:0:0:0: [sda] Synchronizing SCSI cache
[ 205.173876] sd 0:0:0:0: [sda]
[ 205.173919] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
[ 205.177611] md/raid:md1: Disk failure on sda2, disabling device.
[ 205.177611] md/raid:md1: Operation continuing on 11 devices.
[ 205.177653] md/raid1:md0: Disk failure on sda1, disabling device.
[ 205.177653] md/raid1:md0: Operation continuing on 9 devices.
[ 205.234825] md: recovery of RAID array md0
[ 205.234921] md: minimum _guaranteed_ speed: 1000 KB/sec/disk.
[ 205.235016] md: using maximum available idle IO bandwidth (but not
more than 200000 KB/sec) for recovery.
[ 205.235171] md: using 128k window, over a total of 1048512k.
[ 205.244799] md: delaying recovery of md1 until md0 has finished
(they share one or more physical units)
[ 205.304574] md: unbind<sda1>
[ 205.313688] md: unbind<sda2>
[ 205.321117] md: export_rdev(sda1)
[ 205.331098] md: export_rdev(sda2)
[ 214.452649] mptsas: ioc0: attaching sata device: fw_channel 0,
fw_id 0, phy 0, sas_addr 0x1221000000000000
[ 214.459858] scsi 0:0:7:0: Direct-Access ATA WDC
WD2500JD-00H 2D08 PQ: 0 ANSI: 5
[ 214.461941] sd 0:0:7:0: Attached scsi generic sg0 type 0
[ 214.462949] sd 0:0:7:0: [sda] 488397168 512-byte logical blocks:
(250 GB/232 GiB)
[ 214.781445] sd 0:0:7:0: [sda] Write Protect is off
[ 214.788044] sd 0:0:7:0: [sda] Write cache: enabled, read cache:
enabled, doesn't support DPO or FUA
[ 215.017999] sda: sda1 sda2
[ 215.342944] sd 0:0:7:0: [sda] Attached SCSI disk
[ 230.608957] md: md0: recovery done.
[ 230.641045] md: recovery of RAID array md1
[ 230.641140] md: minimum _guaranteed_ speed: 1000 KB/sec/disk.
[ 230.641238] md: using maximum available idle IO bandwidth (but not
more than 200000 KB/sec) for recovery.
[ 230.641394] md: using 128k window, over a total of 243147776k.
localhost ~ # uname -a
Linux localhost
3.5.0-bisect-9-test-scsi-remove-target-fix-00014-g10f8d5b-dirty #10
SMP Tue Aug 28 12:33:16 EDT 2012 x86_64 Intel(R) Xeon(R) CPU E31230 @
3.20GHz GenuineIntel GNU/Linux
localhost ~ # cat /proc/mdstat
Personalities : [raid1] [raid10] [raid6] [raid5] [raid4] [raid0]
[linear] [multipath]
md0 : active raid1 sdj1[0] sdk1[2] sdf1[10](S) sdb1[11](S) sdg1[9]
sdh1[8] sdl1[7] sdm1[6] sde1[5] sdd1[4] sdi1[3] sdc1[1]
1048512 blocks [10/10] [UUUUUUUUUU]
md1 : active raid6 sdk2[17] sdj2[18] sdf2[16] sdm2[19] sdl2[14]
sdi2[12] sdg2[15] sde2[5] sdd2[4] sdh2[21] sdb2[20] sdc2[1]
2431477760 blocks super 1.2 level 6, 512k chunk, algorithm 2
[12/11] [_UUUUUUUUUUU]
[>....................] recovery = 1.2% (3134952/243147776)
finish=100.1min speed=39954K/sec
unused devices: <none>
John
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
