On Wed, Jan 25, 2012 at 03:06:13PM -0500, Chris Mason wrote: > We can talk about scaling up how big the RA windows get on their own, > but if userland asks for 1MB, we don't have to worry about futile RA, we > just have to make sure we don't oom the box trying to honor 1MB reads > from 5000 different procs. :) that's for sure if read has a 1M buffer as destination. However even cp /dev/sda reads/writes through a 32kb buffer, so it's not so common to read in 1m buffers. But I also would prefer to stay on the simple side (on a side note we run out of page flags already on 32bit I think as I had to nuke PG_buddy already). Overall I think the risk of the pages being evicted before they can be copied to userland is quite a minor risk. A 16G system with 100 readers all hitting on disk at the same time using 100M readahead would still only create a 100m memory pressure... So it'd sure be ok, 100m is less than what kswapd keeps always free for example. Think a 4TB system. Especially if 128k fixed has been ok so far on a 1G system. If we really want to be more dynamic than a setting at boot depending on ram size, we could limit it to a fraction of freeable memory (using similar math to determine_dirtyable_memory, maybe calling it over time but not too frequently to reduce the overhead). Like if there's 0 memory freeable keep it low. If there's 1G freeable out of that math (and we assume the readahead hit rate is near 100%), raise the maximum readahead to 1M even if the total ram is only 1G. So we allow up to 1000 readers before we even recycle the readahead. I doubt the complexity of tracking exactly how many pages are getting recycled before they're copied to userland would be worth it, besides it'd be 0% for 99% of systems and workloads. Way more important is to have feedback on the readahead hits and be sure when readahead is raised to the maximum the hit rate is near 100% and fallback to lower readaheads if we don't get that hit rate. But that's not a VM problem and it's a readahead issue only. The actual VM pressure side of it, sounds minor issue if the hit rate of the readahead cache is close to 100%. The config option is also ok with me, but I think it'd be nicer to set it at boot depending on ram size (one less option to configure manually and zero overhead). -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
