Douglas,
I am trying to generate Descriptor format sense data from driver attached to LSI controller.
I have tried few sets of commands on my linux machine. Please help me if anything is wrong here.
1. Output of " sg_inq -d /dev/sg0"
[root@dhcp-135-24-192-117 ~]# sg_inq -d /dev/sg0
standard INQUIRY:
PQual=0 Device_type=0 RMB=0 version=0x06 [SPC-4]
[AERC=0] [TrmTsk=0] NormACA=0 HiSUP=1 Resp_data_format=2
SCCS=0 ACC=0 TPGS=0 3PC=0 Protect=0 BQue=0
EncServ=0 MultiP=0 [MChngr=0] [ACKREQQ=0] Addr16=0
[RelAdr=0] WBus16=0 Sync=0 Linked=0 [TranDis=0] CmdQue=1
[SPI: Clocking=0x0 QAS=0 IUS=0]
length=74 (0x4a) Peripheral device type: disk
Vendor identification: ATA
Product identification: WDC WD30EZRS-00J
Product revision level: 0A80
Unit serial number: WD-WCAWZ0036672
Version descriptors:
SAM-4 (no version claimed)
SAT-2 (no version claimed)
SPC-4 (no version claimed)
SBC-3 (no version claimed)
SAS ANSI INCITS 376-2003
ATA/ATAPI-8 ATA-ACS ATA/ATAPI command set (no version claimed)
2. Output of " sg_requests -v /dev/sg0 -d"
[root@dhcp-135-24-192-117 ~]# sg_requests -v /dev/sg0 -d
Request Sense cmd: 03 01 00 00 fc 00
request sense: Fixed format, current; Sense key: Illegal Request
Additional sense: Invalid field in cdb
bad field in Request Sense cdb
3. Reading beyond the range of drive to get sense data.
Output of "sg_read if=/dev/sg0 cdbsz=16 skip=0x15d50a3af00 bs=512 verbose=3 count=512"
[root@dhcp-135-24-192-117 ~]# sg_read if=/dev/sg0 cdbsz=16 skip=0x15d50a3af00 bs=512 verbose=3 count=512
Opened /dev/sg0 for SG_IO with flags=0x2
SG_GET_RESERVED_SIZE yields: 32768
read cdb: 88 00 00 00 01 5d 50 a3 af 00 00 00 00 80 00 00
duration=123 ms
reading: SCSI status: Check Condition
Fixed format, current; Sense key: Illegal Request
Additional sense: Logical block address out of range
Raw sense data (in hex):
70 00 05 00 00 00 00 0a 00 00 00 00 21 00 00 00
00 00
sg_read: SCSI READ failed
Some error occurred, remaining block count=512
0+0 records in
My Drive is SPC-4 complaint and sg_requests suggested to have SPC-3 or higher version to enable descriptor format.
_But_ for me it is not working.
Eventually, When I try to run command as mentioned in #3, I want to see Descriptor format sense instead of Fixed one.
Thanks, Kashyap
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
