Don't enable the SCSI irq when initialising the chip -- the irq has no handler yet. Signed-off-by: Finn Thain <fthain@xxxxxxxxxxxxxxxxxxx> Index: linux-m68k/drivers/scsi/mac_scsi.c =================================================================== --- linux-m68k.orig/drivers/scsi/mac_scsi.c 2011-10-22 23:02:38.000000000 +1100 +++ linux-m68k/drivers/scsi/mac_scsi.c 2011-10-22 23:44:51.000000000 +1100 @@ -339,9 +339,6 @@ static void mac_scsi_reset_boot(struct S printk(KERN_INFO "Macintosh SCSI: resetting the SCSI bus..." ); - /* switch off SCSI IRQ - catch an interrupt without IRQ bit set else */ - disable_irq(IRQ_MAC_SCSI); - /* get in phase */ NCR5380_write( TARGET_COMMAND_REG, PHASE_SR_TO_TCR( NCR5380_read(STATUS_REG) )); @@ -357,9 +354,6 @@ static void mac_scsi_reset_boot(struct S for( end = jiffies + AFTER_RESET_DELAY; time_before(jiffies, end); ) barrier(); - /* switch on SCSI IRQ again */ - enable_irq(IRQ_MAC_SCSI); - printk(KERN_INFO " done\n" ); } #endif -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
