Re: 2.6.39 and Powerfile c200

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sat, May 28, 2011 at 1:26 PM, Stefan Richter
<stefanr@xxxxxxxxxxxxxxxxx> wrote:
> (Cc: lsml)
>
> On May 27 Jonathan Isom wrote to linux1394-user:
>> After upgrading to 2.6.39,  I'm getting "rejecting I/O to offline
>> device" repeatedly in dmesg.  Full log is attached.
>> I can load disks into the DVD drives, however the drives a not usable.
>>  The Powerfile C200 is a 200 Disk DVD
>> Changer with 2 drives. I didn't turn on the Changer till 249508.718311.
>
> Which is:
>
> [249508.718311] firewire_core: phy config: card 0, new root=ffc1, gap_count=5
> [249509.320382] firewire_core: created device fw1: GUID 003060f200002759, S400
> [249509.458787] scsi8 : SBP-2 IEEE-1394
> [249509.659575] firewire_sbp2: fw1.0: logged in to LUN 0000 (0 retries)
> [249509.661749] scsi 8:0:0:0: CD-ROM            TOSHIBA  DVD-ROM SD-M1212 1032 PQ: 0 ANSI: 0 CCS
> [249509.666218] sr1: scsi3-mmc drive: 32x/32x cd/rw xa/form2 cdda tray
> [249509.666479] sr 8:0:0:0: Attached scsi CD-ROM sr1
> [249509.666611] sr 8:0:0:0: Attached scsi generic sg5 type 5
> [249509.668791] firewire_sbp2: fw1.0: logged in to LUN 0001 (0 retries)
> [249509.671056] scsi 8:0:0:1: CD-ROM            TOSHIBA  DVD-ROM SD-M1212 1032 PQ: 0 ANSI: 0 CCS
> [249509.676162] sr2: scsi3-mmc drive: 32x/32x cd/rw xa/form2 cdda tray
> [249509.676385] sr 8:0:0:1: Attached scsi CD-ROM sr2
> [249509.676514] sr 8:0:0:1: Attached scsi generic sg6 type 5
> [249509.678677] firewire_sbp2: fw1.0: logged in to LUN 0002 (0 retries)
> [249509.683634] scsi 8:0:0:2: Medium Changer    Escient  Powerfile C200   04A  PQ: 0 ANSI: 3
>
> OK.
>
> [249509.685951] ch0: reading element address assigment page failed!
>
> Don't know if this is bad or not.
>
> [249509.685962] ch0: INITIALIZE ELEMENT STATUS, may take some time ...
> [249509.686719] ch0: ... finished
> [249509.686729] ch 8:0:0:2: Attached scsi changer ch0
> [249509.686948] ch 8:0:0:2: Attached scsi generic sg7 type 8
>
> OK.
>
> [249539.712075] firewire_sbp2: fw1.0: sbp2_scsi_abort
> [249549.712062] firewire_sbp2: fw1.0: sbp2_scsi_abort
> [249549.712287] sr 8:0:0:0: Device offlined - not ready after error recovery
> [249549.712393] sr 8:0:0:0: rejecting I/O to offline device
> [249583.704061] firewire_sbp2: fw1.0: sbp2_scsi_abort
> [249593.704070] firewire_sbp2: fw1.0: sbp2_scsi_abort
> [249593.704307] sr 8:0:0:1: Device offlined - not ready after error recovery
> [249593.704423] sr 8:0:0:1: rejecting I/O to offline device
> [249593.706254] sr 8:0:0:0: rejecting I/O to offline device
> [249593.706276] sr 8:0:0:0: rejecting I/O to offline device
> [249593.706948] sr 8:0:0:0: rejecting I/O to offline device
> [249593.706976] sr 8:0:0:0: rejecting I/O to offline device
> [249593.709258] sr 8:0:0:1: rejecting I/O to offline device
> [...repeated almost 2000 times...]
> [250542.004258] sr 8:0:0:0: rejecting I/O to offline device
> [250542.004269] sr 8:0:0:0: rejecting I/O to offline device
> [250542.004340] sr 8:0:0:1: rejecting I/O to offline device
> [250542.004350] sr 8:0:0:1: rejecting I/O to offline device
>
> All three SCSI units were probed and attached successfully.  This involves
> successful execution of a few basic SCSI commands.
>
> 30 seconds after that, and again after additional 10 seconds and further
> 34 seconds + additional 10 seconds, firewire-sbp2 logs that in total four
> SCSI commands timed out.  The kernel's SCSI subsystem decides to take the
> two DVD-ROM logical units offline.
>
> Why the time-outs happened is is not clear.  Also, I have no idea what
> could be done with the kernel's SCSI subsystem so that it logs *which*
> commands timed out.
>
> Was the 2.6.39 kernel update the only change that you did on your system,
> or were there userland updates too?  If yes, maybe you have a program now
> that sends weird commands that crash the Powerfile's firmware.

I have done some updates. Been messing around trying to get it
working. I'm getting
the same problem with 2.6.38.2.  At one point I got a drive to work
under 2.6.39, but not
the other drive and the changer failed to show.  I got an older
firewire mac I'll try messing
with it later to see if there is a failure in the Powerfile.

Thanks for the input.

Jonathan


> --
> Stefan Richter
> -=====-==-== -=-= ===--
> http://arcgraph.de/sr/
>
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Index of Archives]     [SCSI Target Devel]     [Linux SCSI Target Infrastructure]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Linux IIO]     [Samba]     [Device Mapper]
  Powered by Linux