[PATCH 06/11] qla2xxx: Correctly read sfp single byte mailbox register.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Joe Carnuccio <joe.carnuccio@xxxxxxxxxx>

When reading a single byte using the READ SFP mailbox command, the
single byte of data is returned in MB[1] and not MB[8].

The reason that MB[8] was being used is that the spec was unclear
as it evolved over time; and we have not needed to read a single
byte until recently.

Signed-off-by: Joe Carnuccio <joe.carnuccio@xxxxxxxxxx>
Signed-off-by: Madhuranath Iyengar <Madhu.Iyengar@xxxxxxxxxx>
---
 drivers/scsi/qla2xxx/qla_mbx.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/scsi/qla2xxx/qla_mbx.c b/drivers/scsi/qla2xxx/qla_mbx.c
index 975aeaa..aab628b 100644
--- a/drivers/scsi/qla2xxx/qla_mbx.c
+++ b/drivers/scsi/qla2xxx/qla_mbx.c
@@ -3608,14 +3608,14 @@ qla2x00_read_edc(scsi_qla_host_t *vha, uint16_t dev, uint16_t adr,
 	mcp->mb[9] = adr;
 	mcp->mb[10] = opt;
 	mcp->out_mb = MBX_10|MBX_9|MBX_8|MBX_7|MBX_6|MBX_3|MBX_2|MBX_1|MBX_0;
-	mcp->in_mb = MBX_0;
+	mcp->in_mb = MBX_1|MBX_0;
 	mcp->tov = MBX_TOV_SECONDS;
 	mcp->flags = 0;
 	rval = qla2x00_mailbox_command(vha, mcp);
 
 	if (opt & BIT_0)
 		if (sfp)
-			*sfp = mcp->mb[8];
+			*sfp = mcp->mb[1];
 
 	if (rval != QLA_SUCCESS) {
 		DEBUG2_3_11(printk("%s(%ld): failed=%x (%x).\n", __func__,
-- 
1.6.0.2

--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Index of Archives]     [SCSI Target Devel]     [Linux SCSI Target Infrastructure]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Linux IIO]     [Samba]     [Device Mapper]
  Powered by Linux