Is this an on board MPT chip or is it an add-in HBA? I'm not aware of a DID of 0x55. More than likely itâs either a megaraid board or a customer tweaked something of ours. A photo of it if it's an add-in or a link to the product it's in would help narrow it down. Also, if it's an mptlinux card, there should be two identifications on it. Both should be on a white label with a barcode. One will be SAS3####X... The other will be L#-####-###. -----Original Message----- From: Arkadiusz Miskiewicz [mailto:a.miskiewicz@xxxxxxxxx] Sent: Friday, November 19, 2010 12:39 PM To: Moore, Eric Cc: DL-MPT Fusion Linux; linux-scsi@xxxxxxxxxxxxxxx Subject: Re: missing mptsas support for LSI Logic / Symbios Logic SAS1068 PCI-X Fusion-MPT SAS [1000:0055] (rev 02) On Friday 19 of November 2010, Arkadiusz Miskiewicz wrote: > Hi, > > I wonder if mptsas driver is able to support this hardware? > > 04:08.0 SCSI storage controller [0100]: LSI Logic / Symbios Logic SAS1068 > PCI- X Fusion-MPT SAS [1000:0055] (rev 02) > Subsystem: Intel Corporation Device [8086:3504] > > Currently driver doesn't handle 1000:0055 pciid. The problem seems quite > old since I found someone asking for it long time ago > http://lkml.org/lkml/2007/1/23/87 [root@rescue mptsas]# echo 1000 0055 > new_id [root@rescue mptsas]# drives were detected, I was able to create filesystem, write, read few files and these short tests worked well. So I wonder what's the case with it not being added to mptsas driver? Thanks. [ 5689.436551] mptsas 0000:04:08.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16 [ 5689.436886] mptbase: ioc0: Initiating bringup [ 5690.042770] ioc0: : Capabilities={Initiator} [ 5699.421066] scsi8 : ioc0: , FwRev=01120000h, Ports=1, MaxQ=511, IRQ=16 [ 5699.458704] mptsas: ioc0: attaching sata device: fw_channel 0, fw_id 0, phy 0, sas_addr 0x1221000000000000 [ 5699.461495] scsi 8:0:0:0: Direct-Access ATA ST9500420AS SDM1 PQ: 0 ANSI: 5 [ 5699.465182] sd 8:0:0:0: [sda] 976773168 512-byte logical blocks: (500 GB/465 GiB) [ 5699.465822] mptsas: ioc0: attaching sata device: fw_channel 0, fw_id 1, phy 1, sas_addr 0x1221000001000000 [ 5699.466599] sd 8:0:0:0: Attached scsi generic sg0 type 0 [ 5699.469232] scsi 8:0:1:0: Direct-Access ATA ST9500420AS SDM1 PQ: 0 ANSI: 5 [ 5699.471140] sd 8:0:1:0: Attached scsi generic sg1 type 0 [ 5699.472842] sd 8:0:1:0: [sdb] 976773168 512-byte logical blocks: (500 GB/465 GiB) [ 5699.801422] sd 8:0:0:0: [sda] Write Protect is off [ 5699.801425] sd 8:0:0:0: [sda] Mode Sense: 73 00 00 08 [ 5699.806427] sd 8:0:1:0: [sdb] Write Protect is off [ 5699.806431] sd 8:0:1:0: [sdb] Mode Sense: 73 00 00 08 [ 5699.822024] sd 8:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA [ 5699.827135] sd 8:0:1:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA [ 5699.928108] sda: [ 5699.933163] sdb: unknown partition table [ 5699.962440] unknown partition table [ 5700.068369] sd 8:0:0:0: [sda] Attached SCSI disk [ 5700.073759] sd 8:0:1:0: [sdb] Attached SCSI disk -- Arkadiusz MiÅkiewicz PLD/Linux Team arekm / maven.pl http://ftp.pld-linux.org/ ÿô.nlj·Ÿ®‰†+%ŠË±é¥Šwÿº{.nlj·¥Š{±þÇ‹ø¡Ü}©ž²ÆzÚj:+v‰¨þø®w¥þŠàÞ¨è&¢)ß«a¶Úÿûz¹ÞúŽŠÝjÿŠwèf
