From: Andrew Vasquez <andrew.vasquez@xxxxxxxxxx> With qla2xxx using mid-layer async-scsi-scanning, the link state for disconnected port is displayed wrong. Additional check for cable presence is considered to display proper link state. Signed-off-by: Giridhar Malavali <giridhar.malavali@xxxxxxxxxx> --- drivers/scsi/qla2xxx/qla_attr.c | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-) diff --git a/drivers/scsi/qla2xxx/qla_attr.c b/drivers/scsi/qla2xxx/qla_attr.c index d416c35..5c98b09 100644 --- a/drivers/scsi/qla2xxx/qla_attr.c +++ b/drivers/scsi/qla2xxx/qla_attr.c @@ -987,7 +987,8 @@ qla2x00_link_state_show(struct device *dev, struct device_attribute *attr, int len = 0; if (atomic_read(&vha->loop_state) == LOOP_DOWN || - atomic_read(&vha->loop_state) == LOOP_DEAD) + atomic_read(&vha->loop_state) == LOOP_DEAD || + vha->device_flags & DFLG_NO_CABLE) len = snprintf(buf, PAGE_SIZE, "Link Down\n"); else if (atomic_read(&vha->loop_state) != LOOP_READY || test_bit(ABORT_ISP_ACTIVE, &vha->dpc_flags) || -- 1.6.2.rc1.30.gd43c -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
