On Thu, 2009-01-22 at 22:22 -0800, Sudhakar Pannerselvam wrote: > As James mentioned earlier, this is a distribution issue. I had seen > this issue with redhat. If you observe redhat distro qlogic drivers, > they compile firmware files along with the driver and hence they > wouldn't observe this issue when they load through initrd as there is no > firmware loading procedure through hotplug interface, whereas if you > compile qlogic driver by hand without inbuilt firmware files and using > distro's like redhat, you would encounter this issue. This has to be > addressed in nash hotplug code. OK, there is one little wrinkle with Red Hat: nash is a sort of all in one process and it keeps going wrong. I've opened a few bugs with red hat about nash over the years with hotplug issues, which this is, but they always ignore them and then close them when the distro goes end of life. The way I fixed my RH nash problems was to boot the RH distro with a debian created initrd ... which is a bit of a time consuming hack, but it worked. These problems should be going away when Dave Jones finally kills off nash in his initrd/boot system rewrite. James -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
