There's no point in hitting the RISC with what will most
assuredly be an unsucessful reset of the RISC hardware if the
initial stop-firmware mailbox command fails with a time-out
status. Instead, to avoid what could amount to a lengthy
stop-firmware/detect-failure/reset-risc loop, continue with
driver unloading and discard the stop-firmware requirement.
Signed-off-by: Andrew Vasquez <andrew.vasquez@xxxxxxxxxx>
---
drivers/scsi/qla2xxx/qla_init.c | 3 ++-
1 files changed, 2 insertions(+), 1 deletions(-)
diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index d5c7853..4897663 100644
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -4022,7 +4022,8 @@ qla2x00_try_to_stop_firmware(scsi_qla_host_t *ha)
return;
ret = qla2x00_stop_firmware(ha);
- for (retries = 5; ret != QLA_SUCCESS && retries ; retries--) {
+ for (retries = 5; ret != QLA_SUCCESS && ret != QLA_FUNCTION_TIMEOUT &&
+ retries ; retries--) {
qla2x00_reset_chip(ha);
if (qla2x00_chip_diag(ha) != QLA_SUCCESS)
continue;
--
1.5.4.3.230.g2db511
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
