From: Seokmann Ju <seokmann.ju@xxxxxxxxxx>
There is a case where 54xx HBA loads MID firmware as it use 24xx
firmware. In this case, the driver should issue
MBC_MID_INITIALIZE FIRMWARE even though the HBA doesn't support
NPIV. This patch make changes in the driver so that could behave
accordingly.
Signed-off-by: Seokmann Ju <seokmann.ju@xxxxxxxxxx>
---
drivers/scsi/qla2xxx/qla_init.c | 4 +++-
drivers/scsi/qla2xxx/qla_mbx.c | 2 +-
2 files changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index 7637fa7..d0633ca 100644
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -1193,7 +1193,9 @@ qla2x00_init_rings(scsi_qla_host_t *ha)
DEBUG(printk("scsi(%ld): Issue init firmware.\n", ha->host_no));
- mid_init_cb->count = cpu_to_le16(ha->max_npiv_vports);
+ if (ha->flags.npiv_supported)
+ mid_init_cb->count = cpu_to_le16(ha->max_npiv_vports);
+
mid_init_cb->options = __constant_cpu_to_le16(BIT_1);
rval = qla2x00_init_firmware(ha, ha->init_cb_size);
diff --git a/drivers/scsi/qla2xxx/qla_mbx.c b/drivers/scsi/qla2xxx/qla_mbx.c
index 99d29ff..0c10c0b 100644
--- a/drivers/scsi/qla2xxx/qla_mbx.c
+++ b/drivers/scsi/qla2xxx/qla_mbx.c
@@ -980,7 +980,7 @@ qla2x00_init_firmware(scsi_qla_host_t *ha, uint16_t size)
DEBUG11(printk("qla2x00_init_firmware(%ld): entered.\n",
ha->host_no));
- if (ha->flags.npiv_supported)
+ if (ha->fw_attributes & BIT_2)
mcp->mb[0] = MBC_MID_INITIALIZE_FIRMWARE;
else
mcp->mb[0] = MBC_INITIALIZE_FIRMWARE;
--
1.5.4.rc3.14.g44397
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
