Issue a Diag-reset when the "Doorbell-In-Use" bit
is set during the driver load/initialization.
Signed-off-by: Ranjan Kumar <ranjan.kumar@xxxxxxxxxxxx>
---
drivers/scsi/mpt3sas/mpt3sas_base.c | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/drivers/scsi/mpt3sas/mpt3sas_base.c b/drivers/scsi/mpt3sas/mpt3sas_base.c
index ed5046593fda..16ac2267c71e 100644
--- a/drivers/scsi/mpt3sas/mpt3sas_base.c
+++ b/drivers/scsi/mpt3sas/mpt3sas_base.c
@@ -7041,11 +7041,12 @@ _base_handshake_req_reply_wait(struct MPT3SAS_ADAPTER *ioc, int request_bytes,
int i;
u8 failed;
__le32 *mfp;
+ int ret_val;
/* make sure doorbell is not in use */
if ((ioc->base_readl_ext_retry(&ioc->chip->Doorbell) & MPI2_DOORBELL_USED)) {
ioc_err(ioc, "doorbell is in use (line=%d)\n", __LINE__);
- return -EFAULT;
+ goto doorbell_diag_reset;
}
/* clear pending doorbell interrupts from previous state changes */
@@ -7135,6 +7136,10 @@ _base_handshake_req_reply_wait(struct MPT3SAS_ADAPTER *ioc, int request_bytes,
le32_to_cpu(mfp[i]));
}
return 0;
+
+doorbell_diag_reset:
+ ret_val = _base_diag_reset(ioc);
+ return ret_val;
}
/**
--
2.31.1
