CC'ing the fibre channel experts because they might have the same issue.
On 10/11/24 3:18 AM, Xiang Zhang wrote:
> Initiator need to recover session and reconnect to target, after calling stop_conn. And target will rebuild new session info, and mark ASC_POWERON_RESET ua sense for scsi devices belong to the target(device reset). After recovery, first scsi command(scmd) request to target will get ASC_POWERON_RESET(ua sense) + SAM_STAT_CHECK_CONDITION(status) in response.
> According to scsi code: "scsi_done --> scsi_complete --> scsi_decide_disposition --> scsi_check_sense", if expecting_cc_ua = 0, scmd response with ASC_POWERON_RESET(ua sense) will ignore "cmd->retries <= cmd->allowed", fail directly. It will cause SCSI return io_error to upper layer without retry.
Just want to make sure I understand the problem.
Does the failure only happen with tape or passthrough or if removable is
set?
For commands coming from sd, then scsi_io_completion will end up calling
scsi_io_completion_action and seeing the UNIT_ATTENTION and will retry.
I'm not saying we shouldn't do a fix like you did below. Just want to
make sure I understand the case you describe above.
> If we set expecting_cc_ua=1 in fail_scsi_tasks, SISC will retry the scmd which is response with ASC_POWERON_RESET. The scmd second request to target can successful, because target will clear ASC_POWERON_RESET in device pending ua_sense_list after first scmd request.
What does "SISC" stand for?
>
> Signed-off-by: Xiang Zhang <hawkxiang.cpp@xxxxxxxxx>
> ---
> drivers/scsi/libiscsi.c | 5 +++--
> 1 file changed, 3 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/scsi/libiscsi.c b/drivers/scsi/libiscsi.c
> index 0fda8905eabd..317e57be32b3 100644
> --- a/drivers/scsi/libiscsi.c
> +++ b/drivers/scsi/libiscsi.c
> @@ -629,9 +629,10 @@ static void __fail_scsi_task(struct iscsi_task *task, int err)
> conn->session->queued_cmdsn--;
> /* it was never sent so just complete like normal */
> state = ISCSI_TASK_COMPLETED;
> - } else if (err == DID_TRANSPORT_DISRUPTED)
> + } else if (err == DID_TRANSPORT_DISRUPTED) {
> state = ISCSI_TASK_ABRT_SESS_RECOV;
> - else
> + sc->device->expecting_cc_ua = 1;
The failure case can happen with other transports like fibre channel
right? If it's common I think we want this in the core scsi code.
For iscsi, we want to set expecting_cc_ua whenever we call
scsi_block_targets() or whenever we return DID_TRANSPORT_DISRUPTED or
DID_TRANSPORT_FAILFAST.
FC developers, I'm not sure if that's the case for you. For example if
your driver called fc_remote_port_delete -> scsi_block_targets but then
the issue is resolved quickly, like for a quick cable pull, and you
called fc_remote_port_add, could there be cases where you did not get a
I_T Nexus loss/reset type of issue?
Or is it the case where anytime a fc driver calls fc_remote_port_delete
then you will expect a UA after calling fc_remote_port_add again?
