On Sat, 02 Dec 2023 04:36:06 -0800, Can Guo wrote: > This series enables HS-G5 support on SM8550. > > This series is rebased on below changes from Mani - > https://patchwork.kernel.org/project/linux-scsi/patch/20230908145329.154024-1-manivannan.sadhasivam@xxxxxxxxxx/ > https://patchwork.kernel.org/project/linux-scsi/patch/20230908145329.154024-2-manivannan.sadhasivam@xxxxxxxxxx/ > > This series is tested on below HW combinations - > SM8550 MTP + UFS4.0 > SM8550 QRD + UFS3.1 > SM8450 MTP + UFS3.1 (for regression test) > SM8350 MTP + UFS3.1 (for regression test) > > [...] Applied to 6.8/scsi-queue, thanks! [01/10] scsi: ufs: host: Rename structure ufs_dev_params to ufs_host_params https://git.kernel.org/mkp/scsi/c/fa3dca8251c4 [02/10] scsi: ufs: ufs-qcom: No need to set hs_rate after ufshcd_init_host_param() https://git.kernel.org/mkp/scsi/c/dc604b4c9d60 [03/10] scsi: ufs: ufs-qcom: Setup host power mode during init https://git.kernel.org/mkp/scsi/c/55820a7f2cb9 [04/10] scsi: ufs: ufs-qcom: Allow the first init start with the maximum supported gear https://git.kernel.org/mkp/scsi/c/743e1f596ccc [05/10] scsi: ufs: ufs-qcom: Limit HS-G5 Rate-A to hosts with HW version 5 https://git.kernel.org/mkp/scsi/c/9d8528a833fc [06/10] scsi: ufs: ufs-qcom: Set initial PHY gear to max HS gear for HW ver 4 and newer https://git.kernel.org/mkp/scsi/c/0bd3cb895d19 [07/10] scsi: ufs: ufs-qcom: Check return value of phy_set_mode_ext() https://git.kernel.org/mkp/scsi/c/a68abdadfe13 [08/10] scsi: ufs: ufs-qcom: Add support for UFS device version detection https://git.kernel.org/mkp/scsi/c/dc7c948d74e1 -- Martin K. Petersen Oracle Linux Engineering
