Re: [PATCH 2/6] scsi: ufs: ufs-qcom: Add support for UFS device version detection

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 18/10/2023 16:02, Neil Armstrong wrote:
On 11/09/2023 07:59, Can Guo wrote:
From: "Bao D. Nguyen" <quic_nguyenb@xxxxxxxxxxx>

Retrieve UFS device version from UFS host controller's spare register
which is populated by bootloader, and use the UFS device version together
with host controller's HW version to decide the proper power modes which
should be used to configure the UFS PHY.

Signed-off-by: Bao D. Nguyen <quic_nguyenb@xxxxxxxxxxx>
Signed-off-by: Can Guo <quic_cang@xxxxxxxxxxx>
---
  drivers/ufs/host/ufs-qcom.c | 30 +++++++++++++++++++++++-------
  drivers/ufs/host/ufs-qcom.h |  2 ++
  2 files changed, 25 insertions(+), 7 deletions(-)

diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
index 710f079..8a9d54f 100644
--- a/drivers/ufs/host/ufs-qcom.c
+++ b/drivers/ufs/host/ufs-qcom.c
@@ -1030,7 +1030,7 @@ static void ufs_qcom_advertise_quirks(struct ufs_hba *hba)
                  | UFSHCD_QUIRK_BROKEN_PA_RXHSUNTERMCAP);
      }
-    if (host->hw_ver.major > 0x3)
+    if (host->hw_ver.major > 0x3 && host->hw_ver.major < 0x5)
          hba->quirks |= UFSHCD_QUIRK_REINIT_AFTER_MAX_GEAR_SWITCH;
  }
@@ -1038,11 +1038,33 @@ static void ufs_qcom_set_pwr_mode_limits(struct ufs_hba *hba)
  {
      struct ufs_qcom_host *host = ufshcd_get_variant(hba);
      struct ufs_dev_params *host_pwr_cap = &host->host_pwr_cap;
+    u32 val, dev_major = 0;
      ufshcd_init_pwr_dev_param(host_pwr_cap);
      /* This driver only supports symmetic gear setting i.e., hs_tx_gear == hs_rx_gear */
      host_pwr_cap->hs_tx_gear = host_pwr_cap->hs_rx_gear = ufs_qcom_get_hs_gear(hba);
+    host->phy_gear = host_pwr_cap->hs_rx_gear;
+
+    if (host->hw_ver.major < 0x5) {

Here you set G2 for < 0x5

+        /*
+         * Power up the PHY using the minimum supported gear (UFS_HS_G2).
+         * Switching to max gear will be performed during reinit if supported.
+         */
+        host->phy_gear = UFS_HS_G2;
+    } else {

So here is for >= 0x5

+        val = ufshcd_readl(host->hba, REG_UFS_DEBUG_SPARE_CFG);
+        dev_major = FIELD_GET(GENMASK(7, 4), val);
+
+        if (host->hw_ver.major == 0x5 && (dev_major >= 0x4 ||
+                          dev_major == 0)) {
+            /* For UFS 4.0 and newer, or dev version is not populated */
+            host_pwr_cap->hs_rate = PA_HS_MODE_A;
+        } else if (dev_major < 0x4 && dev_major > 0) {
+            /* For UFS 3.1 and older, apply HS-G4 PHY settings to save power */
+            host->phy_gear = UFS_HS_G4;
+        }

But behavior of > 0x5 is not clear here, could you clarify it in v2 ?

Now SM8650 is public, could you update it for v2 ?

Thanks,
Neil


Thanks,
Neil

+    }
  }
  static void ufs_qcom_set_caps(struct ufs_hba *hba)
@@ -1287,12 +1309,6 @@ static int ufs_qcom_init(struct ufs_hba *hba)
          dev_warn(dev, "%s: failed to configure the testbus %d\n",
                  __func__, err);
-    /*
-     * Power up the PHY using the minimum supported gear (UFS_HS_G2).
-     * Switching to max gear will be performed during reinit if supported.
-     */
-    host->phy_gear = UFS_HS_G2;
-
      return 0;
  out_variant_clear:
diff --git a/drivers/ufs/host/ufs-qcom.h b/drivers/ufs/host/ufs-qcom.h
index 4db64d9..e10889f 100644
--- a/drivers/ufs/host/ufs-qcom.h
+++ b/drivers/ufs/host/ufs-qcom.h
@@ -56,6 +56,8 @@ enum {
      UFS_AH8_CFG                = 0xFC,
      REG_UFS_CFG3                = 0x271C,
+
+    REG_UFS_DEBUG_SPARE_CFG            = 0x284C,
  };
  /* QCOM UFS host controller vendor specific debug registers */





[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Index of Archives]     [SCSI Target Devel]     [Linux SCSI Target Infrastructure]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Linux IIO]     [Samba]     [Device Mapper]

  Powered by Linux