On 10/16/23 09:05, Christoph Hellwig wrote:
On Mon, Oct 16, 2023 at 09:02:11AM +0200, Milan Broz wrote:
All common USB/SATA or USB/NVMe adapters I tested need this patch.
In short, these steps are run for OPAL support check:
1) Storage driver enables security driver flag (security_supported).
USB-attached storage drivers will enable it in a separate patchset.
SCSI and NNVMe drivers do it already. If the flag is not enabled,
no following steps are run, and OPAL remains disabled.
2) SCSI device enumerates SECURITY IN/OUT command support. If detected,
SECURITY ON/OUT wrapper is used (as in the current code).
If not, new ATA-12 pass-thru wrapper is used instead.
3) SED OPAL code tries OPAL discovery command for the device.
If it receives a correct reply, OPAL is enabled for the device.
If SCSI SECURITY or ATA-12 command with discovery command is rejected,
OPAL remains disabled.
Note, USB attached storage needs an additional patchset sent separately
as requested by USB driver maintainers (it contains required changes
related to USB quirk processing).
This just feels wrong. These adapters are broken if they can't
translated, and we should not put ATA command submission into
sd.c.
I think it is blocked in USB layer as not running command enumeration,
SCSI SECURITY will be never sent to the adapter through USB.
I understand the problem, but if you configure OPAL from userspace, ATA-12 is sent
to these devices already - so why kernel cannot use it too?
+ cdb[0] = ATA_12;
+ cdb[1] = (send ? 5 /* ATA_PROTOCOL_PIO_DATA_IN */ : 4 /* ATA_PROTOCOL_PIO_DATA_OUT */) << 1;
+ cdb[2] = 2 /* t_length */ | (1 << 2) /* byt_blok */ | ((send ? 0 : 1) << 3) /* t_dir */;
+ cdb[3] = secp;
+ put_unaligned_le16(len / 512, &cdb[4]);
+ put_unaligned_le16(spsp, &cdb[6]);
+ cdb[9] = send ? 0x5e /* ATA_CMD_TRUSTED_SND */: 0x5c /* ATA_CMD_TRUSTED_RCV */;
Also avoid all these crazy long lines, and please use the actual
constants. Using a good old if/else is actually a very good way to
structure the code in a somewhat readable way.
Sure, I was trying to no add additional includes that will mess this up, I'll reformat it if needed.
Otherwise, this wrapper is exactly what is used is sedutils and also in our test utility
that tries to work with OPAL commands directly
https://github.com/mbroz/opal-toolset
+ if (sdkp->security)
+ sdkp->opal_dev = init_opal_dev(sdkp, &sd_sec_submit);
+ else
+ sdkp->opal_dev = init_opal_dev(sdkp, &sd_ata12_submit);
Messed up indentation here.
sorry, my bad, I hate such formatting myself and missed it here :-)
besides the fact that the statement is fundamentally wrong and you'll
start sending ATA command to random devices.
So what do you suggest? As I said, this exactly happen if you configure it from userspace.
Can this be somehow limited? I did not find and way how to do it.
Milan
