From: Quinn Tran <qutran@xxxxxxxxxxx>
After adapter reset, the appearance of link is not recovered,
the devices were not rediscovered.
This is result of a race condition between adapter reset (abort_isp)
and the topology scan.
During adapter reset, the ABORT_ISP_ACTIVE flag is set.
Topology scan usually occurred after adapter reset.
In this case, the topology scan came earlier than usual where it
ran into problem due to ABORT_ISP_ACTIVE flag was still set.
kernel: qla2xxx [0000:13:00.0]-1005:1: Cmd 0x6a aborted with timeout since ISP Abort is pending
kernel: qla2xxx [0000:13:00.0]-28a0:1: MBX_GET_PORT_NAME failed, No FL Port.
kernel: qla2xxx [0000:13:00.0]-286b:1: qla2x00_configure_loop: exiting normally. local port wwpn 51402ec0123d9a80 id 012300)
kernel: qla2xxx [0000:13:00.0]-8017:1: ADAPTER RESET SUCCEEDED nexus=1:0:15.
Allow adapter reset to complete before any scan can start.
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Quinn Tran <qutran@xxxxxxxxxxx>
Signed-off-by: Nilesh Javali <njavali@xxxxxxxxxxx>
Reviewed-by: Himanshu Madhani <himanshu.madhani@xxxxxxxxxx>
---
drivers/scsi/qla2xxx/qla_os.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/scsi/qla2xxx/qla_os.c b/drivers/scsi/qla2xxx/qla_os.c
index 36d3cecab20e..2d86f804872b 100644
--- a/drivers/scsi/qla2xxx/qla_os.c
+++ b/drivers/scsi/qla2xxx/qla_os.c
@@ -7094,9 +7094,12 @@ qla2x00_do_dpc(void *data)
}
}
loop_resync_check:
- if (test_and_clear_bit(LOOP_RESYNC_NEEDED,
+ if (!qla2x00_reset_active(base_vha) &&
+ test_and_clear_bit(LOOP_RESYNC_NEEDED,
&base_vha->dpc_flags)) {
-
+ /*
+ * Allow abort_isp to complete before moving on to scanning.
+ */
ql_dbg(ql_dbg_dpc, base_vha, 0x400f,
"Loop resync scheduled.\n");
--
2.19.0.rc0
