> From: Peter Wang <peter.wang@xxxxxxxxxxxx>
>
> Device WLun may enter RPM_SUSPENDED and the consumer is RPM_ACTIVE.
>
> The error state is
> Device Wlun RPM: status:2, usage_count:0
> Consumer: 0:0:0:49476 Link: rpm_active:1, RPM: status:2, usage_count:0
> Consumer: 0:0:0:49456 Link: rpm_active:1, RPM: status:2, usage_count:0
> Consumer: 0:0:0:0 Link: rpm_active:1, RPM: status:2, usage_count:0
> Consumer: 0:0:0:1 Link: rpm_active:1, RPM: status:2, usage_count:0
> Consumer: 0:0:0:2 Link: rpm_active:1, RPM: status:0, usage_count:0
>
> Because rpm enable before rpm delay set, scsi_autopm_put_device
> invoke by scsi_sysfs_add_sdev may cause consumer enter suspend
> immediately.
> Thas will always set rpm_active to 1.
> If driver_probe_device invoke pm_runtime_get_suppliers just befor
> previous scsi_autopm_put_device, the rpm_active will change to 1
> after pm_runtime_put_suppliers.
> Set this delay to avoid scsi_autopm_put_device enter suspend immediately.
>
> Signed-off-by: Peter Wang <peter.wang@xxxxxxxxxxxx>
> ---
> drivers/scsi/ufs/ufshcd.c | 8 ++++++--
> 1 file changed, 6 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
> index 3f9caafa91bf..1250792d16be 100644
> --- a/drivers/scsi/ufs/ufshcd.c
> +++ b/drivers/scsi/ufs/ufshcd.c
> @@ -5024,10 +5024,14 @@ static int ufshcd_slave_configure(struct
> scsi_device *sdev)
> * Block runtime-pm until all consumers are added.
> * Refer ufshcd_setup_links().
> */
> - if (is_device_wlun(sdev))
> + if (is_device_wlun(sdev)) {
> pm_runtime_get_noresume(&sdev->sdev_gendev);
> - else if (ufshcd_is_rpm_autosuspend_allowed(hba))
> + } else if (ufshcd_is_rpm_autosuspend_allowed(hba)) {
> sdev->rpm_autosuspend = 1;
> + pm_runtime_set_autosuspend_delay(&sdev->sdev_gendev,
> + RPM_AUTOSUSPEND_DELAY_MS);
> + }
Maybe remove ufshcd_blk_pm_runtime_init from ufshcd_scsi_add_wlus,
And call here ufshcd_blk_pm_runtime_init() ?
Thanks,
Avri
> +
> /*
> * Do not print messages during runtime PM to avoid never-ending cycles
> * of messages written back to storage by user space causing runtime
> --
> 2.18.0
