Aborting commands that have already been sent to the firmware can
cause BUG in qlt_free_cmd(): BUG_ON(cmd->sg_mapped)
For instance:
- command passes rdx_to_xfer state, maps sgl, sends to the
fimware
- reset occurs, qla2xxx performs ISP error recovery,
aborts the command
- target stack calls qlt_abort_cmd() and then qlt_free_cmd()
- BUG_ON(cmd->sg_mapped) in qlt_free_cmd() occurs because sgl was not
unmapped
Thus, unmap sgl in qlt_abort_cmd() for commands with the aborted flag
set.
Signed-off-by: Gleb Chesnokov <Chesnokov.G@xxxxxxxxxx>
---
drivers/scsi/qla2xxx/qla_target.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/scsi/qla2xxx/qla_target.c b/drivers/scsi/qla2xxx/qla_target.c
index 2d30578aebcf..a02235a6a8e9 100644
--- a/drivers/scsi/qla2xxx/qla_target.c
+++ b/drivers/scsi/qla2xxx/qla_target.c
@@ -3826,6 +3826,9 @@ int qlt_abort_cmd(struct qla_tgt_cmd *cmd)
spin_lock_irqsave(&cmd->cmd_lock, flags);
if (cmd->aborted) {
+ if (cmd->sg_mapped)
+ qlt_unmap_sg(vha, cmd);
+
spin_unlock_irqrestore(&cmd->cmd_lock, flags);
/*
* It's normal to see 2 calls in this path:
--
2.35.1
