Executing driver on servers with more than 32 CPUs were faced with command timeouts. This is because we were not geting completions for commands submitted on IQ32 - IQ63. Set E64Q bit to enable upper inbound and outbound queues 32 to 63 in the MPI main configuration table. Added 500ms delay after successful MPI initialization as mentioned in controller datasheet. Signed-off-by: Ajish Koshy <Ajish.Koshy@xxxxxxxxxxxxx> Signed-off-by: Viswas G <Viswas.G@xxxxxxxxxxxxx> --- drivers/scsi/pm8001/pm80xx_hwi.c | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/drivers/scsi/pm8001/pm80xx_hwi.c b/drivers/scsi/pm8001/pm80xx_hwi.c index b92e82a576e3..f04c6c589615 100644 --- a/drivers/scsi/pm8001/pm80xx_hwi.c +++ b/drivers/scsi/pm8001/pm80xx_hwi.c @@ -766,6 +766,10 @@ static void init_default_table_values(struct pm8001_hba_info *pm8001_ha) pm8001_ha->main_cfg_tbl.pm80xx_tbl.pcs_event_log_severity = 0x01; pm8001_ha->main_cfg_tbl.pm80xx_tbl.fatal_err_interrupt = 0x01; + /* Enable higher IQs and OQs, 32 to 63, bit 16*/ + if (pm8001_ha->max_q_num > 32) + pm8001_ha->main_cfg_tbl.pm80xx_tbl.fatal_err_interrupt |= + (1 << 16); /* Disable end to end CRC checking */ pm8001_ha->main_cfg_tbl.pm80xx_tbl.crc_core_dump = (0x1 << 16); @@ -1027,6 +1031,9 @@ static int mpi_init_check(struct pm8001_hba_info *pm8001_ha) if (0x0000 != gst_len_mpistate) return -EBUSY; + /* Wait for 500ms after successful MPI initialization*/ + msleep(500); + return 0; } -- 2.31.1
