On 2/15/22 9:49 AM, Zhengyuan Liu wrote:
> Hi, all
>
> We have an online server which uses multipath + iscsi to attach storage
> from Storage Server. There are two NICs on the server and for each it
> carries about 20 iscsi sessions and for each session it includes about 50
> iscsi devices (yes, there are totally about 2*20*50=2000 iscsi block devices
> on the server). The problem is: once a NIC gets faulted, it will take too long
> (nearly 80s) for multipath to switch to another good NIC link, because it
> needs to block all iscsi devices over that faulted NIC firstly. The callstack is
> shown below:
>
> void iscsi_block_session(struct iscsi_cls_session *session)
> {
> queue_work(iscsi_eh_timer_workq, &session->block_work);
> }
>
> __iscsi_block_session() -> scsi_target_block() -> target_block() ->
> device_block() -> scsi_internal_device_block() -> scsi_stop_queue() ->
> blk_mq_quiesce_queue()>synchronize_rcu()
>
> For all sessions and all devices, it was processed sequentially, and we have
> traced that for each synchronize_rcu() call it takes about 80ms, so
> the total cost
> is about 80s (80ms * 20 * 50). It's so long that the application can't
> tolerate and
> may interrupt service.
>
> So my question is that can we optimize the procedure to reduce the time cost on
> blocking all iscsi devices? I'm not sure if it is a good idea to increase the
> workqueue's max_active of iscsi_eh_timer_workq to improve concurrency.
We need a patch, so the unblock call waits/cancels/flushes the block call or
they could be running in parallel.
I'll send a patchset later today so you can test it.
