On 26/11/2021 15:35, John Garry wrote:
/*
@@ -4280,8 +4283,9 @@ static int pm80xx_chip_smp_req(struct pm8001_hba_info *pm8001_ha,
pm8001_ha->smp_exp_mode = SMP_INDIRECT;
- tmp_addr = cpu_to_le64((u64)sg_dma_address(&task->smp_task.smp_req));
- preq_dma_addr = (char *)phys_to_virt(tmp_addr);
+ smp_req = &task->smp_task.smp_req;
+ to = kmap(sg_page(smp_req));
This should be a kmap_atomic() as well, as I see the following for when
CONFIG_DEBUG_ATOMIC_SLEEP is enabled:
[ 27.222116] dump_backtrace+0x0/0x2b4
[ 27.225774] show_stack+0x1c/0x30
[ 27.229084] dump_stack_lvl+0x68/0x84
[ 27.232741] dump_stack+0x20/0x3c
[ 27.236049] __might_resched+0x1d4/0x240
[ 27.239967] __might_sleep+0x70/0xd0
[ 27.243536] pm80xx_chip_smp_req+0x2c4/0x56c
[ 27.247802] pm8001_task_exec.constprop.0+0x718/0x770
[ 27.252848] pm8001_queue_command+0x1c/0x2c
[ 27.257026] smp_execute_task_sg+0x1e8/0x370
[ 27.261289] sas_ex_phy_discover+0x29c/0x31c
[ 27.265553] smp_ata_check_ready+0x74/0x190
[ 27.269729] ata_wait_ready+0xd0/0x224
[ 27.273474] ata_wait_after_reset+0x78/0xac
[ 27.277652] sas_ata_hard_reset+0xf0/0x18c
[ 27.281742] ata_do_reset.constprop.0+0x80/0x9c
[ 27.286266] ata_eh_reset+0xba4/0x1170
[ 27.290008] ata_eh_recover+0x4b0/0x1b40
[ 27.293924] ata_do_eh+0x8c/0x110
[ 27.297232] ata_std_error_handler+0x80/0xb0
[ 27.301495] ata_scsi_port_error_handler+0x3d4/0x9d0
[ 27.306454] async_sas_ata_eh+0x70/0xf8
[ 27.310285] async_run_entry_fn+0x5c/0x1e0
[ 27.314375] process_one_work+0x378/0x630
[ 27.318379] worker_thread+0xa8/0x6bc
[ 27.322033] kthread+0x214/0x230
[ 27.325256] ret_from_fork+0x10/0x20
[ 27.328825] pm80xx0:: pm80xx_chip_smp_req 4292:SMP REQUEST INDIRECT MODE
But I don't think that this is the problem which causes error handling
to kick in later, as discussed in this thread.
+ payload = to + smp_req->offset;
/* INDIRECT MODE command settings. Use DMA */
if (pm8001_ha->smp_exp_mode == SMP_INDIRECT) {
@@ -4289,7 +4293,7 @@ static int pm80xx_chip_smp_req(struct pm8001_hba_info *pm8001_ha,
/* for SPCv indirect mode. Place the top 4 bytes of
* SMP Request header here. */
for (i = 0; i < 4; i++)
- smp_cmd.smp_req16[i] = *(preq_dma_addr + i);
+ smp_cmd.smp_req16[i] = *(payload + i);
