Extraneous teardown routines are present in the firmware dump path causing
altered states in firmware captures.
When a firmware dump is requested via sysfs, trigger the dump immediately
without tearing down structures and changing adapter state.
The driver shall rely on pre-existing firmware error state clean up
handlers to restore the adapter.
Co-developed-by: Justin Tee <justin.tee@xxxxxxxxxxxx>
Signed-off-by: Justin Tee <justin.tee@xxxxxxxxxxxx>
Signed-off-by: James Smart <jsmart2021@xxxxxxxxx>
---
drivers/scsi/lpfc/lpfc.h | 2 +-
drivers/scsi/lpfc/lpfc_attr.c | 62 ++++++++++++++++++++------------
drivers/scsi/lpfc/lpfc_hbadisc.c | 8 ++++-
drivers/scsi/lpfc/lpfc_sli.c | 6 ----
4 files changed, 48 insertions(+), 30 deletions(-)
diff --git a/drivers/scsi/lpfc/lpfc.h b/drivers/scsi/lpfc/lpfc.h
index a04995832459..e652926fb47a 100644
--- a/drivers/scsi/lpfc/lpfc.h
+++ b/drivers/scsi/lpfc/lpfc.h
@@ -1021,7 +1021,6 @@ struct lpfc_hba {
#define HBA_DEVLOSS_TMO 0x2000 /* HBA in devloss timeout */
#define HBA_RRQ_ACTIVE 0x4000 /* process the rrq active list */
#define HBA_IOQ_FLUSH 0x8000 /* FCP/NVME I/O queues being flushed */
-#define HBA_FW_DUMP_OP 0x10000 /* Skips fn reset before FW dump */
#define HBA_RECOVERABLE_UE 0x20000 /* Firmware supports recoverable UE */
#define HBA_FORCED_LINK_SPEED 0x40000 /*
* Firmware supports Forced Link Speed
@@ -1038,6 +1037,7 @@ struct lpfc_hba {
#define HBA_HBEAT_TMO 0x8000000 /* HBEAT initiated after timeout */
#define HBA_FLOGI_OUTSTANDING 0x10000000 /* FLOGI is outstanding */
+ struct completion *fw_dump_cmpl; /* cmpl event tracker for fw_dump */
uint32_t fcp_ring_in_use; /* When polling test if intr-hndlr active*/
struct lpfc_dmabuf slim2p;
diff --git a/drivers/scsi/lpfc/lpfc_attr.c b/drivers/scsi/lpfc/lpfc_attr.c
index dd4c51b6ef4e..7a7f17d71811 100644
--- a/drivers/scsi/lpfc/lpfc_attr.c
+++ b/drivers/scsi/lpfc/lpfc_attr.c
@@ -1709,25 +1709,25 @@ lpfc_sli4_pdev_reg_request(struct lpfc_hba *phba, uint32_t opcode)
before_fc_flag = phba->pport->fc_flag;
sriov_nr_virtfn = phba->cfg_sriov_nr_virtfn;
- /* Disable SR-IOV virtual functions if enabled */
- if (phba->cfg_sriov_nr_virtfn) {
- pci_disable_sriov(pdev);
- phba->cfg_sriov_nr_virtfn = 0;
- }
+ if (opcode == LPFC_FW_DUMP) {
+ init_completion(&online_compl);
+ phba->fw_dump_cmpl = &online_compl;
+ } else {
+ /* Disable SR-IOV virtual functions if enabled */
+ if (phba->cfg_sriov_nr_virtfn) {
+ pci_disable_sriov(pdev);
+ phba->cfg_sriov_nr_virtfn = 0;
+ }
- if (opcode == LPFC_FW_DUMP)
- phba->hba_flag |= HBA_FW_DUMP_OP;
+ status = lpfc_do_offline(phba, LPFC_EVT_OFFLINE);
- status = lpfc_do_offline(phba, LPFC_EVT_OFFLINE);
+ if (status != 0)
+ return status;
- if (status != 0) {
- phba->hba_flag &= ~HBA_FW_DUMP_OP;
- return status;
+ /* wait for the device to be quiesced before firmware reset */
+ msleep(100);
}
- /* wait for the device to be quiesced before firmware reset */
- msleep(100);
-
reg_val = readl(phba->sli4_hba.conf_regs_memmap_p +
LPFC_CTL_PDEV_CTL_OFFSET);
@@ -1756,24 +1756,42 @@ lpfc_sli4_pdev_reg_request(struct lpfc_hba *phba, uint32_t opcode)
lpfc_printf_log(phba, KERN_ERR, LOG_SLI,
"3153 Fail to perform the requested "
"access: x%x\n", reg_val);
+ if (phba->fw_dump_cmpl)
+ phba->fw_dump_cmpl = NULL;
return rc;
}
/* keep the original port state */
- if (before_fc_flag & FC_OFFLINE_MODE)
- goto out;
-
- init_completion(&online_compl);
- job_posted = lpfc_workq_post_event(phba, &status, &online_compl,
- LPFC_EVT_ONLINE);
- if (!job_posted)
+ if (before_fc_flag & FC_OFFLINE_MODE) {
+ if (phba->fw_dump_cmpl)
+ phba->fw_dump_cmpl = NULL;
goto out;
+ }
- wait_for_completion(&online_compl);
+ /* Firmware dump will trigger an HA_ERATT event, and
+ * lpfc_handle_eratt_s4 routine already handles bringing the port back
+ * online.
+ */
+ if (opcode == LPFC_FW_DUMP) {
+ wait_for_completion(phba->fw_dump_cmpl);
+ } else {
+ init_completion(&online_compl);
+ job_posted = lpfc_workq_post_event(phba, &status, &online_compl,
+ LPFC_EVT_ONLINE);
+ if (!job_posted)
+ goto out;
+ wait_for_completion(&online_compl);
+ }
out:
/* in any case, restore the virtual functions enabled as before */
if (sriov_nr_virtfn) {
+ /* If fw_dump was performed, first disable to clean up */
+ if (opcode == LPFC_FW_DUMP) {
+ pci_disable_sriov(pdev);
+ phba->cfg_sriov_nr_virtfn = 0;
+ }
+
sriov_err =
lpfc_sli_probe_sriov_nr_virtfn(phba, sriov_nr_virtfn);
if (!sriov_err)
diff --git a/drivers/scsi/lpfc/lpfc_hbadisc.c b/drivers/scsi/lpfc/lpfc_hbadisc.c
index 802fd30a9fb8..816fc406135b 100644
--- a/drivers/scsi/lpfc/lpfc_hbadisc.c
+++ b/drivers/scsi/lpfc/lpfc_hbadisc.c
@@ -869,10 +869,16 @@ lpfc_work_done(struct lpfc_hba *phba)
if (phba->pci_dev_grp == LPFC_PCI_DEV_OC)
lpfc_sli4_post_async_mbox(phba);
- if (ha_copy & HA_ERATT)
+ if (ha_copy & HA_ERATT) {
/* Handle the error attention event */
lpfc_handle_eratt(phba);
+ if (phba->fw_dump_cmpl) {
+ complete(phba->fw_dump_cmpl);
+ phba->fw_dump_cmpl = NULL;
+ }
+ }
+
if (ha_copy & HA_MBATT)
lpfc_sli_handle_mb_event(phba);
diff --git a/drivers/scsi/lpfc/lpfc_sli.c b/drivers/scsi/lpfc/lpfc_sli.c
index 5dedb3de271d..513a78d08b1d 100644
--- a/drivers/scsi/lpfc/lpfc_sli.c
+++ b/drivers/scsi/lpfc/lpfc_sli.c
@@ -5046,12 +5046,6 @@ lpfc_sli4_brdreset(struct lpfc_hba *phba)
phba->fcf.fcf_flag = 0;
spin_unlock_irq(&phba->hbalock);
- /* SLI4 INTF 2: if FW dump is being taken skip INIT_PORT */
- if (phba->hba_flag & HBA_FW_DUMP_OP) {
- phba->hba_flag &= ~HBA_FW_DUMP_OP;
- return rc;
- }
-
/* Now physically reset the device */
lpfc_printf_log(phba, KERN_INFO, LOG_INIT,
"0389 Performing PCI function reset!\n");
--
2.26.2
