> -----Original Message----- > From: linux-scsi-owner@xxxxxxxxxxxxxxx > [mailto:linux-scsi-owner@xxxxxxxxxxxxxxx] On Behalf Of Douglas Gilbert > Sent: Tuesday, May 22, 2007 1:29 PM > To: Haefliger, Juerg > Cc: linux-scsi@xxxxxxxxxxxxxxx > Subject: Re: Sg_ses question > > Haefliger, Juerg wrote: > > Hi, > > > > Not sure if this is the right list for my question but I > couldn't find > > a more suitable place to ask it. > > > > I'm trying to set the locator light of a disk in a SAS > enclosure using > > sg_ses but I'm not getting anywhere. I'm dumping the > enclosure status > > diagnostic page using 'sg_ses --page=2 --raw /dev/sgXX > page' and > > then set the SELECT and RQST IDENT bits of the array device > element in > > question and write it back doing 'sg_ses --control --page=2 > --data=- > > /dev/sgXX < tmp'. The command completes without error but > > unfortunately, nothing happens. When I read the page back, > the IDENT > > bit is still cleared and the light on the enclosure remains > turned off. > > > > Am I doing something wrong or am I missing something? Can't I use > > sg_ses to achieve this? > > The procedure looks correct. I haven't had any (other) > reports of sg_ses not working lately. The only suggestion I > can make is to ask if you have selected the element control > rather than the overall control. Hmm... Just tried it again and now it works. I don't think I did something different than before... Thanks ...juerg > Doug Gilbert > > > > > - > To unsubscribe from this list: send the line "unsubscribe > linux-scsi" in the body of a message to > majordomo@xxxxxxxxxxxxxxx More majordomo info at > http://vger.kernel.org/majordomo-info.html > - To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
