On 27/07/2021 04:44, lijinlin3@xxxxxxxxxx wrote:
From: lijinlin <lijinlin3@xxxxxxxxxx>
After add physical volumes to a volume group through vgextend, kernel
will rescan partitions, which will read the capacity of the device.
If the device status is set to offline through sysfs at this time,
read capacity command will return a result which the host byte is
DID_NO_CONNECT, the capacity of the device will be set to zero in
read_capacity_error(). However, the capacity of the device can't be
reread after reset the device status to running, is still zero.
Fix this issue by rescan device when the device state changes to
SDEV_RUNNING.
Signed-off-by: lijinlin <lijinlin3@xxxxxxxxxx>
Signed-off-by: Wu Bo <wubo40@xxxxxxxxxx>
---
drivers/scsi/scsi_sysfs.c | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)
diff --git a/drivers/scsi/scsi_sysfs.c b/drivers/scsi/scsi_sysfs.c
index 32489d25158f..ae9bfc658203 100644
--- a/drivers/scsi/scsi_sysfs.c
+++ b/drivers/scsi/scsi_sysfs.c
@@ -807,11 +807,14 @@ store_state_field(struct device *dev, struct device_attribute *attr,
mutex_lock(&sdev->state_mutex);
ret = scsi_device_set_state(sdev, state);
/*
- * If the device state changes to SDEV_RUNNING, we need to run
- * the queue to avoid I/O hang.
+ * If the device state changes to SDEV_RUNNING, we need to
+ * rescan the device to revalidate it, and run the queue to
+ * avoid I/O hang.
*/
- if (ret == 0 && state == SDEV_RUNNING)
+ if (ret == 0 && state == SDEV_RUNNING) {
+ scsi_rescan_device(dev);
blk_mq_run_hw_queues(sdev->request_queue, true);
I am wondering does any of this need to be done with the device state
mutex held?
Thanks,
John
+ }
mutex_unlock(&sdev->state_mutex);
return ret == 0 ? count : -EINVAL;
