[PATCH 076/117] nsp32: Convert to the scsi_status union

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 

An explanation of the purpose of this patch is available in the patch
"scsi: Introduce the scsi_status union".

Cc: GOTO Masanori <gotom@xxxxxxxxxxxx>
Cc: YOKOTA Hiroshi <yokota@xxxxxxxxxxxxxxxxxxxxxxx>
Signed-off-by: Bart Van Assche <bvanassche@xxxxxxx>
---
 drivers/scsi/nsp32.c | 40 ++++++++++++++++++++--------------------
 1 file changed, 20 insertions(+), 20 deletions(-)

diff --git a/drivers/scsi/nsp32.c b/drivers/scsi/nsp32.c
index 134bbd2d8b66..d084d7cd7e08 100644
--- a/drivers/scsi/nsp32.c
+++ b/drivers/scsi/nsp32.c
@@ -461,7 +461,7 @@ static int nsp32_selection_autopara(struct scsi_cmnd *SCpnt)
 	if (phase != BUSMON_BUS_FREE) {
 		nsp32_msg(KERN_WARNING, "bus busy");
 		show_busphase(phase & BUSMON_PHASE_MASK);
-		SCpnt->result = DID_BUS_BUSY << 16;
+		SCpnt->status.combined = DID_BUS_BUSY << 16;
 		return FALSE;
 	}
 
@@ -473,7 +473,7 @@ static int nsp32_selection_autopara(struct scsi_cmnd *SCpnt)
 	 */
 	if (data->msgout_len == 0) {
 		nsp32_msg(KERN_ERR, "SCSI MsgOut without any message!");
-		SCpnt->result = DID_ERROR << 16;
+		SCpnt->status.combined = DID_ERROR << 16;
 		return FALSE;
 	} else if (data->msgout_len > 0 && data->msgout_len <= 3) {
 		msgout = 0;
@@ -596,7 +596,7 @@ static int nsp32_selection_autoscsi(struct scsi_cmnd *SCpnt)
 	phase = nsp32_read1(base, SCSI_BUS_MONITOR);
 	if ((phase & BUSMON_BSY) || (phase & BUSMON_SEL)) {
 		nsp32_msg(KERN_WARNING, "bus busy");
-		SCpnt->result = DID_BUS_BUSY << 16;
+		SCpnt->status.combined = DID_BUS_BUSY << 16;
 		status = 1;
 		goto out;
         }
@@ -632,7 +632,7 @@ static int nsp32_selection_autoscsi(struct scsi_cmnd *SCpnt)
 	 */
 	if (data->msgout_len == 0) {
 		nsp32_msg(KERN_ERR, "SCSI MsgOut without any message!");
-		SCpnt->result = DID_ERROR << 16;
+		SCpnt->status.combined = DID_ERROR << 16;
 		status = 1;
 		goto out;
 	} else if (data->msgout_len > 0 && data->msgout_len <= 3) {
@@ -762,11 +762,11 @@ static int nsp32_arbitration(struct scsi_cmnd *SCpnt, unsigned int base)
 
 	if (arbit & ARBIT_WIN) {
 		/* Arbitration succeeded */
-		SCpnt->result = DID_OK << 16;
+		SCpnt->status.combined = DID_OK << 16;
 		nsp32_index_write1(base, EXT_PORT, LED_ON); /* PCI LED on */
 	} else if (arbit & ARBIT_FAIL) {
 		/* Arbitration failed */
-		SCpnt->result = DID_BUS_BUSY << 16;
+		SCpnt->status.combined = DID_BUS_BUSY << 16;
 		status = FALSE;
 	} else {
 		/*
@@ -774,7 +774,7 @@ static int nsp32_arbitration(struct scsi_cmnd *SCpnt, unsigned int base)
 		 * something lock up! guess no connection.
 		 */
 		nsp32_dbg(NSP32_DEBUG_AUTOSCSI, "arbit timeout");
-		SCpnt->result = DID_NO_CONNECT << 16;
+		SCpnt->status.combined = DID_NO_CONNECT << 16;
 		status = FALSE;
         }
 
@@ -910,7 +910,7 @@ static int nsp32_queuecommand_lck(struct scsi_cmnd *SCpnt, void (*done)(struct s
 	if (data->CurrentSC != NULL) {
 		nsp32_msg(KERN_ERR, "Currentsc != NULL. Cancel this command request");
 		data->CurrentSC = NULL;
-		SCpnt->result   = DID_NO_CONNECT << 16;
+		SCpnt->status.combined   = DID_NO_CONNECT << 16;
 		done(SCpnt);
 		return 0;
 	}
@@ -918,7 +918,7 @@ static int nsp32_queuecommand_lck(struct scsi_cmnd *SCpnt, void (*done)(struct s
 	/* check target ID is not same as this initiator ID */
 	if (scmd_id(SCpnt) == SCpnt->device->host->this_id) {
 		nsp32_dbg(NSP32_DEBUG_QUEUECOMMAND, "target==host???");
-		SCpnt->result = DID_BAD_TARGET << 16;
+		SCpnt->status.combined = DID_BAD_TARGET << 16;
 		done(SCpnt);
 		return 0;
 	}
@@ -926,7 +926,7 @@ static int nsp32_queuecommand_lck(struct scsi_cmnd *SCpnt, void (*done)(struct s
 	/* check target LUN is allowable value */
 	if (SCpnt->device->lun >= MAX_LUN) {
 		nsp32_dbg(NSP32_DEBUG_QUEUECOMMAND, "no more lun");
-		SCpnt->result = DID_BAD_TARGET << 16;
+		SCpnt->status.combined = DID_BAD_TARGET << 16;
 		done(SCpnt);
 		return 0;
 	}
@@ -958,7 +958,7 @@ static int nsp32_queuecommand_lck(struct scsi_cmnd *SCpnt, void (*done)(struct s
 	ret = nsp32_setup_sg_table(SCpnt);
 	if (ret == FALSE) {
 		nsp32_msg(KERN_ERR, "SGT fail");
-		SCpnt->result = DID_ERROR << 16;
+		SCpnt->status.combined = DID_ERROR << 16;
 		nsp32_scsi_done(SCpnt);
 		return 0;
 	}
@@ -1181,7 +1181,7 @@ static irqreturn_t do_nsp32_isr(int irq, void *dev_id)
 		nsp32_msg(KERN_INFO, "card disconnect");
 		if (data->CurrentSC != NULL) {
 			nsp32_msg(KERN_INFO, "clean up current SCSI command");
-			SCpnt->result = DID_BAD_TARGET << 16;
+			SCpnt->status.combined = DID_BAD_TARGET << 16;
 			nsp32_scsi_done(SCpnt);
 		}
 		goto out;
@@ -1199,7 +1199,7 @@ static irqreturn_t do_nsp32_isr(int irq, void *dev_id)
 		nsp32_msg(KERN_INFO, "detected someone do bus reset");
 		nsp32_do_bus_reset(data);
 		if (SCpnt != NULL) {
-			SCpnt->result = DID_RESET << 16;
+			SCpnt->status.combined = DID_RESET << 16;
 			nsp32_scsi_done(SCpnt);
 		}
 		goto out;
@@ -1227,7 +1227,7 @@ static irqreturn_t do_nsp32_isr(int irq, void *dev_id)
 			nsp32_dbg(NSP32_DEBUG_INTR,
 				  "selection timeout occurred");
 
-			SCpnt->result = DID_TIME_OUT << 16;
+			SCpnt->status.combined = DID_TIME_OUT << 16;
 			nsp32_scsi_done(SCpnt);
 			goto out;
 		}
@@ -1309,7 +1309,7 @@ static irqreturn_t do_nsp32_isr(int irq, void *dev_id)
 			 * low level driver to indicate status), then checks 
 			 * status_byte (SCSI status byte).
 			 */
-			SCpnt->result =	(int)nsp32_read1(base, SCSI_CSB_IN);
+			SCpnt->status.combined = (int)nsp32_read1(base, SCSI_CSB_IN);
 		}
 
 		if (auto_stat & ILLEGAL_PHASE) {
@@ -1504,8 +1504,8 @@ static int nsp32_show_info(struct seq_file *m, struct Scsi_Host *host)
 
 
 /*
- * Reset parameters and call scsi_done for data->cur_lunt.
- * Be careful setting SCpnt->result = DID_* before calling this function.
+ * Reset parameters and call scsi_done for data->cur_lunt. Be careful setting
+ * SCpnt->status.combined = DID_* before calling this function.
  */
 static void nsp32_scsi_done(struct scsi_cmnd *SCpnt)
 {
@@ -1670,7 +1670,7 @@ static int nsp32_busfree_occur(struct scsi_cmnd *SCpnt, unsigned short execph)
 		nsp32_dbg(NSP32_DEBUG_BUSFREE, 
 			  "normal end stat=0x%x resid=0x%x\n",
 			  SCpnt->SCp.Status, scsi_get_resid(SCpnt));
-		SCpnt->result = (DID_OK             << 16) |
+		SCpnt->status.combined = (DID_OK    << 16) |
 			        (SCpnt->SCp.Message <<  8) |
 			        (SCpnt->SCp.Status  <<  0);
 		nsp32_scsi_done(SCpnt);
@@ -1689,7 +1689,7 @@ static int nsp32_busfree_occur(struct scsi_cmnd *SCpnt, unsigned short execph)
 
 		/* DID_ERROR? */
 		//SCpnt->result   = (DID_OK << 16) | (SCpnt->SCp.Message << 8) | (SCpnt->SCp.Status << 0);
-		SCpnt->result = DID_ERROR << 16;
+		SCpnt->status.combined = DID_ERROR << 16;
 		nsp32_scsi_done(SCpnt);
 		return TRUE;
 	}
@@ -2812,7 +2812,7 @@ static int nsp32_eh_abort(struct scsi_cmnd *SCpnt)
 	nsp32_write2(base, TRANSFER_CONTROL, 0);
 	nsp32_write2(base, BM_CNT,           0);
 
-	SCpnt->result = DID_ABORT << 16;
+	SCpnt->status.combined = DID_ABORT << 16;
 	nsp32_scsi_done(SCpnt);
 
 	nsp32_dbg(NSP32_DEBUG_BUSRESET, "abort success");
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Index of Archives]     [SCSI Target Devel]     [Linux SCSI Target Infrastructure]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Linux IIO]     [Samba]     [Device Mapper]

  Powered by Linux