On Saturday, March 17, 2007 2:33 PM, James W. Laferriere wrote: > Hello All , I am have been having this problem since I > purchased the > controller and after changing out the disks I thought were > the problem . > I am still getting the continous : > > mptscsih: ioc1: attempting task abort! (sc=f7a64500) > scsi 3:0:4:0: > command: Inquiry: 12 00 00 00 60 00 > mptbase: Initiating ioc1 recovery > mptscsih: ioc1: task abort: SUCCESS (sc=f7a64500) > target3:0:4: Domain Validation detected failure, dropping back > target3:0:4: Domain Validation skipping write tests > target3:0:4: Ending Domain Validation > target3:0:4: asynchronous > target3:0:5: Beginning Domain Validation > mptscsih: ioc0: attempting target reset! (sc=f7a64380) > > The acutual device id's change and the driver > continously resets the > busses & starts all over . > > The disks are in a HP DS-SL13R-BA 4354R 14drive ultra3 > racKmount cabinet > w/ dualbus & dualps , Which seems to present a ID6 , That > does not show up in > any of the bus scans . > > Now I have previously had the same cabinet with 18gb > disks which had the > same problem with this controller . BUT I also have a LSI > Logic / Symbios > Logic 53c1010 66MHz Ultra3 dual SCSI bus Adapter which works > flawlessly with the > 18gb disks in this very same cabinet . > The cables for connecting the adapter(s) to tha cabinet > are less than 24 > inches in length . > > Would anyone please shed some light on what it is I am > doing wrong or > need to do or ....? Too have this controller recognise these > disk drives in > this cabinet . There is a seperate mailing list for scsi releated issues, e.g. linux-scsi@. I've posted a patch to address your issue several times, however it seems its not been picked up by the scsi subsystem maintainer. The last time it was posted was here: http://marc.info/?l=linux-scsi&m=117089244809072&w=2 An alternative is you could obtain our latest drivers from the LSI download site, where these drivers should have this patch http://www.lsilogic.com/cm/DownloadSearch.do. Eric - To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
