[PATCH v1 4/4] scsi: ufs-dwc: Use phy_initialization helper

[Stanley Chu <stanley.chu@xxxxxxxxxxxx>]

Use phy_initialization helper instead of direct invoking.

Reviewed-by: Avri Altman <avri.altman@xxxxxxx>
Signed-off-by: Stanley Chu <stanley.chu@xxxxxxxxxxxx>
---
 drivers/scsi/ufs/ufshcd-dwc.c | 11 ++++-------
 1 file changed, 4 insertions(+), 7 deletions(-)

diff --git a/drivers/scsi/ufs/ufshcd-dwc.c b/drivers/scsi/ufs/ufshcd-dwc.c
index 6a901da2d15a..5bb9d3a88795 100644
--- a/drivers/scsi/ufs/ufshcd-dwc.c
+++ b/drivers/scsi/ufs/ufshcd-dwc.c
@@ -120,13 +120,10 @@ int ufshcd_dwc_link_startup_notify(struct ufs_hba *hba,
 	if (status == PRE_CHANGE) {
 		ufshcd_dwc_program_clk_div(hba, DWC_UFS_REG_HCLKDIV_DIV_125);
 
-		if (hba->vops->phy_initialization) {
-			err = hba->vops->phy_initialization(hba);
-			if (err) {
-				dev_err(hba->dev, "Phy setup failed (%d)\n",
-									err);
-				goto out;
-			}
+		err = ufshcd_vops_phy_initialization(hba);
+		if (err) {
+			dev_err(hba->dev, "Phy setup failed (%d)\n", err);
+			goto out;
 		}
 	} else { /* POST_CHANGE */
 		err = ufshcd_dwc_link_is_up(hba);
-- 
2.18.0