Re: [PATCH] scsi: sd: stop SSD (non-rotational) disks before reboot

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 18/06/2020 09:36, Damien Le Moal wrote:
> On 2020/06/18 3:50, Simon Arlott wrote:
>> I need to use "reboot=p" on my desktop because one of the PCIe devices
>> does not appear after a warm boot. This results in a very cold boot
>> because the BIOS turns the PSU off and on.
>> 
>> The scsi sd shutdown process does not send a stop command to disks
>> before the reboot happens (stop commands are only sent for a shutdown).
>> 
>> The result is that all of my SSDs experience a sudden power loss on
>> every reboot, which is undesirable behaviour. These events are recorded
>> in the SMART attributes.
> 
> Why is it undesirable for an SSD ? The sequence you are describing is not
> different from doing "shutdown -h now" and then pressing down the power button
> again immediately after power is cut...

On a shutdown the kernel will send a stop command to the SSD. It does
not currently do this for a reboot so I observe the unexpected power
loss counters increasing.

> Are you experiencing data loss or corruption ? If yes, since a clean reboot or
> shutdown issues a synchronize cache to all devices, a corruption would mean that
> your SSD is probably not correctly processing flush cache commands.

No, I'm not experiencing any data loss or corruption that I'm aware of.

We can argue whether or not any given SSD correctly processes commands
to flush the cache, but they are expecting to be stopped before power
is removed.

>> Avoiding a stop of the disk on a reboot is appropriate for HDDs because
>> they're likely to continue to be powered (and should not be told to spin
>> down only to spin up again) but the default behaviour for SSDs should
>> be changed to stop them before the reboot.
> 
> If your BIOS turns the PSU down and up, then the HDDs too will lose power... The
> difference will be that the disks will still be spinning from inertia on the
> power up, and so the HDD spin up processing will be faster than for a pure cold
> boot sequence.

I haven't verified it, but the BIOS leaves the power off for several
seconds which should be long enough for the HDDs to spin down.

I'm less concerned about those suddenly losing power but it would be
nice to have a stop command sent to them too.

-- 
Simon Arlott



[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Index of Archives]     [SCSI Target Devel]     [Linux SCSI Target Infrastructure]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Linux IIO]     [Samba]     [Device Mapper]

  Powered by Linux