Hi! I've developed a monitoring plugin that reads /sys/class/fc_host/hostX/statistics for numbers. I'm not very happy about it for the following reasons: 1) Some numbers (e.g. fcp_frame_alloc_failures) are not supported by some drivers (e.g. QLE2690) and the value read from the file is "0xffffffffffffffff". The source seems to set this to -1, but when reading it back it looks like unsigned. For a 64-bit counter it's quite unlikely to read this value, but it's still possible. 2) While statistics counters seems to be 64 bits, I've experienced a "wrap around" at fewer bit positions (maybe like 40 bits) for the bfa driver. I have no idea whether it's a hardware restriction or a firmware/driver bug, however. I did my best to make sure it's not a problem of my plugin (assuming those counters are read atomically when using one read()) 3) The bfa drivers has an (maybe even two) "offlines" event counter, but that is not exported to fc_host statistics (it seems to me). I've seen several "bfa 0000:0e:00.0: Target (WWN = 50:01:43:80:11:36:89:da) connectivity lost for initiator (WWN = 10:00:00:05:1e:fb:3e:a0)" in syslog, but I'd like to see such events through statistics. 4) The bfa driver (QLogic-815) sets link_failure_count to 1 after a clean reboot. This triggers the monitoring plugin reporting a "link failure". That's not very nice. My idea was (probably more universal than restricted to FC host statistics) to provide another file (maybe named "statistics") that lists the names of implemented statistics counters (i.e.: leaving out those set to -1) together with the significant bits (like 32 or 64), the type of the value (like "counter", "gauge", "boolean", "enum", "string", etc.) "string" would be free text (I doubt it will make sense for statistics, but anyhow), "enum" would be single word tokens (e.g. _not_ " NPort (fabric via point-to-point)"), "counter" would count bytes or events (maybe a type "event_count[er]" may make sense), and "gauge" would be a non-monotonic value like utilization... Finally an example what the existing "statistics" directory contains (4.12.14-95.51-default from SLES12 SP4): /sys/class/fc_host/host0/statistics/dumped_frames: 0x0 /sys/class/fc_host/host0/statistics/error_frames: 0x0 /sys/class/fc_host/host0/statistics/fc_no_free_exch: 0x0 /sys/class/fc_host/host0/statistics/fc_no_free_exch_xid: 0x0 /sys/class/fc_host/host0/statistics/fc_non_bls_resp: 0x0 /sys/class/fc_host/host0/statistics/fc_seq_not_found: 0x0 /sys/class/fc_host/host0/statistics/fc_xid_busy: 0x0 /sys/class/fc_host/host0/statistics/fc_xid_not_found: 0x0 /sys/class/fc_host/host0/statistics/fcp_control_requests: 0x0 /sys/class/fc_host/host0/statistics/fcp_frame_alloc_failures: 0x0 /sys/class/fc_host/host0/statistics/fcp_input_megabytes: 0x0 /sys/class/fc_host/host0/statistics/fcp_input_requests: 0x0 /sys/class/fc_host/host0/statistics/fcp_output_megabytes: 0x0 /sys/class/fc_host/host0/statistics/fcp_output_requests: 0x0 /sys/class/fc_host/host0/statistics/fcp_packet_aborts: 0x0 /sys/class/fc_host/host0/statistics/fcp_packet_alloc_failures: 0x0 /sys/class/fc_host/host0/statistics/invalid_crc_count: 0x0 /sys/class/fc_host/host0/statistics/invalid_tx_word_count: 0x0 /sys/class/fc_host/host0/statistics/link_failure_count: 0x1 /sys/class/fc_host/host0/statistics/lip_count: 0x0 /sys/class/fc_host/host0/statistics/loss_of_signal_count: 0x0 /sys/class/fc_host/host0/statistics/loss_of_sync_count: 0x0 /sys/class/fc_host/host0/statistics/nos_count: 0x0 /sys/class/fc_host/host0/statistics/prim_seq_protocol_err_count: 0x0 /sys/class/fc_host/host0/statistics/reset_statistics: () /sys/class/fc_host/host0/statistics/rx_frames: 0x18221 /sys/class/fc_host/host0/statistics/rx_words: 0x1a3e8f9 /sys/class/fc_host/host0/statistics/seconds_since_last_reset: 0x2a79 /sys/class/fc_host/host0/statistics/tx_frames: 0x77f4 /sys/class/fc_host/host0/statistics/tx_words: 0x82483 And here's what 4.12.14-122.17-default (SLES12 SP5) contains for a different FC host: /sys/class/fc_host/host3/statistics/dumped_frames: 0x0 /sys/class/fc_host/host3/statistics/error_frames: 0x0 /sys/class/fc_host/host3/statistics/fc_no_free_exch: 0xffffffffffffffff /sys/class/fc_host/host3/statistics/fc_no_free_exch_xid: 0xffffffffffffffff /sys/class/fc_host/host3/statistics/fc_non_bls_resp: 0xffffffffffffffff /sys/class/fc_host/host3/statistics/fc_seq_not_found: 0xffffffffffffffff /sys/class/fc_host/host3/statistics/fc_xid_busy: 0xffffffffffffffff /sys/class/fc_host/host3/statistics/fc_xid_not_found: 0xffffffffffffffff /sys/class/fc_host/host3/statistics/fcp_control_requests: 0x19 /sys/class/fc_host/host3/statistics/fcp_frame_alloc_failures: 0xffffffffffffffff /sys/class/fc_host/host3/statistics/fcp_input_megabytes: 0x2829 /sys/class/fc_host/host3/statistics/fcp_input_requests: 0x114b54e /sys/class/fc_host/host3/statistics/fcp_output_megabytes: 0x11cbf /sys/class/fc_host/host3/statistics/fcp_output_requests: 0xd87b98 /sys/class/fc_host/host3/statistics/fcp_packet_aborts: 0xffffffffffffffff /sys/class/fc_host/host3/statistics/fcp_packet_alloc_failures: 0xffffffffffffffff /sys/class/fc_host/host3/statistics/invalid_crc_count: 0x0 /sys/class/fc_host/host3/statistics/invalid_tx_word_count: 0x0 /sys/class/fc_host/host3/statistics/link_failure_count: 0x0 /sys/class/fc_host/host3/statistics/lip_count: 0x0 /sys/class/fc_host/host3/statistics/loss_of_signal_count: 0x0 /sys/class/fc_host/host3/statistics/loss_of_sync_count: 0x0 /sys/class/fc_host/host3/statistics/nos_count: 0x0 /sys/class/fc_host/host3/statistics/prim_seq_protocol_err_count: 0x0 /sys/class/fc_host/host3/statistics/rx_frames: 0x43a5ec7 /sys/class/fc_host/host3/statistics/rx_words: 0x2829a23ac /sys/class/fc_host/host3/statistics/seconds_since_last_reset: 0x57dffc /sys/class/fc_host/host3/statistics/tx_frames: 0x4b9e39d /sys/class/fc_host/host3/statistics/tx_words: 0x11cbf9bc00 So it's hard to tell which FC HBA supports which statistics numbers... The only message I see from bfa after boot (regarding link_failure_count set to 1) is "kernel: bfa 0000:0e:00.0: Logical port online: WWN = 10:00:00:05:1e:fb:3e:a0 Role = Initiator"... Regards, Ulrich Windl
